General Discussions - 300ZX Related

Driving to the office this morning on the M3, I looked over to my left and there was a woman in a brand new BMW doing 120 mph per hour with her face up next to her rear view mirror putting on her eyeliner! I looked away for a couple of seconds and when I looked back she was halfway over in my lane, still working on that makeup!!! It scared me so bad, I dropped my shaver, which knocked the donut out of my other hand. In all the confusion of trying to straighten out the car using my knees against the steering wheel, it knocked my cell phone away from my ear which fell into the coffee between my legs, splashed and burned Big Jim and the twins, ruined the da…

hi guys, the revs at idle seems to be high. even once warmed it still idles at about 1250 to 1300 rpm. does anyone have any suggestions? thanks aki

Woow...what crazy drivers First time in my life I watch something like this for real. I was standing on a big corner followed by a straight line and then a small corner. It was also downhill where suddenly I hear this engine rev badly and bang..the first car shows up. It was Gronholm-Rautiainen with Peugeot 206. He showed up on the corner and in a few seconds he was gone leaving a big cloud of dust. I couldnt believe it. You expect them to take out a gear or two to slow the car down but noo no. They change gears up to make it go faster. Fucking hell. Panizi, Burns, Makinen, Mcrae and everybody else. All the respect for their madness

please help !!! where can i find pre made air vents for inercoolers,or am i gonna have to custom make em

don't try this with your Zed http://300zx-twinturbo.com/vidz/Parking.mpeg

Tripped over this :- http://www.tuneparts.co.uk/cgi-bin/shop/shop.cgi/page=odds.htm/SID=PUT_SID_HERE and wondered whether the smaller connectors would suit coils or injectors. Any ideas ?

Got my Courtesy stuff this morning mate, thankyou very much. Money for postage is on its way this afternoon bud. Top bloke!!! ------------------

I saw a black 300zx on M1 coming south near jct21 Leicester. It had loads of flash graphics over it inlcuding a massive yellow HKS up the side. Is this a demo car or what? ------------------ Z first and anything else is secondary! John Newcomb (NukeEm) www.geocities.com/jn300zxtt

Does the wiper link between the motor and the wiper arms include the plastic bits that pop onto the motor (I think that may be refered to as seals) or do they need to be bought seperately? When fitting do you need to grease the inside of the plastic bits, and if so with what type of grease. My wiper link popped off last night while driving past an HGV is the pissing rain. Lost all visibility when the wipers stopped. PANIC!!!!!!!!!!!

Does anyone know where i can get it and not at stillen it costs $399 there.

Westfield XTR2: Powered by a GSXR1300R Suzuki Hayabusa engine(mid-mounted) with a 6 speed constant mesh sequential box and a road trim weight of 440kg! This thing is supposed to fly!! Cost: approx £12,000ish for the DIY kit or £23,000ish for a built one. Have a look at the Can-Am orange one here - http://yellowmelon.dnsalias.com/xtr2/xtrtesting.htm or http://www.xtr2.net/ Trev P.S anyone wanna go halves on one?

How can you till the difference between:- 1.A ceased turbo 2.waste gate stuck open 3.on safety boost When driving the car ??? Ken

Thanks Glen got that program today It's the bollocks mate cheerZ. MAC. ------------------

Can anyone please explain the differences in Manual & Auto ECU's. Nissan Fast lists the Manual one as 23710- 37800 & Auto as 23710- 37810. I have been looking for one for an Auto since mine was robbed, and have got hold of one with the number on it- 23710 73C05- not listed on Fast- can anyone tell me which it is? Many Thanks, Dave

For some reason completly beyond me - i can see whos sending a mail but theres no txt with it. The last sucsessful mail was Mac's. The rest who have mailed, i can see names but no info. I will set up an account on a friends pc so keep it sain! till i get going again. I will post new addy 2moro hopefully. Iain, tried to send mail of my address :-( i'll have to send a txt on phone. How annoying is this - bloody hell. harve

can anybody tell me how much it will cost to replace my tie rods or tension bushes, can anybody recomend a decent garage up north. ive been using falcon engineering in middlesbrough and found them expensive .

Does anybody know where i can buy a pre made vent for my front nose cone?I am having vents cut for my intercoolers and was going to just use mesh on the inside of the bumper

ok, i was wondering if anyone new anyone or anywhere to get my japanese documents translated. i have got a load of service document type thingys that i cant read for plop. i think ive got a load of documents that are the jap equivalent of MOT's - except they are every 2 years instead of 1. ive also got that 'Jasma' certificate that says the exhaust system is ok - except ive got 2. - one has HKS on it and the other has Zees. so not sure what the crack is there. Just wondering if anyone could read japanese or perhaps knows somewhere i can take my stuff. anyone? cheers, BEn.

probably a stupid question, but better to be safe. When getting the car up on 4 axle stands, is it as easy as lift the front and put in on stands. Then lift the back and put in on stands. I just have this horrible thought of the car moving when the front's already up and I'm lifting the rear. Cheers Vijay

Seeing as I dont know what any of you look like and you dont know me and im sure a lot of you dont know each other i felt like a gallery, should prive a laugh as well lol So ill start the ball rolling come on get ur shots in btw that has been taken a year ago, I dont have any other photos to my knowledge on the computer so thats it. I probably have grown and changed since then though. ------------------

Hi everyone. Need a bit of help with a part that i discovered on my Z this afternoon? Posted the details on the Technical forum just now. Any help from the wealth of Z knowledge out there would great! Who said knowledge was power??? Cheers

Hi peeps, need a bit of help identifying a strange extendable, telescopic type aerial thingy with some kind of green light at the tip? Messing about this afternoon trying to fix my eratic idling again on my 91 Z TT (jap) and as you do, started to remove the n/s indicator lens ( dont ask!), anyway, attached to the front n/s fog light, inside the spoiler, was this contraption looking a bit broken on the telescopic shaft bit where it joins the motor body and a black and white wire hanging by fresh air. It was also disconnected so pushed the two block connecters together and it started to extend to about 12 inches???? If it was connected to the fog bracket the way it was, the…

Spotted light blue Z with round rear lights and blacked out windows at around 5.30pm on the A61 heading towards Sheffield.

Right ladies, have any of you got one or had the opportunity to play with one? Boost controller I mean, not a real girl! LMFAO After much humming and ha-haaaing over boost I have decided not to have a fixed jet install but go for something more flexi. I like the Blitz but there's a sort of Darth Vader presence about the GReddy, looks like Lord Invaders flashing light panel on his chest plate!!! ROFL Here's a pic... Someone mentioned, I think, that the new Blitz is 32 bit whereas the GReddy is 16 bit but uses fuzzy bear logic. Does the Blitz use fuzzy??? TIA ------------------ [This message has been edit…

does anyone no the web address for silvia engineering se-nissan.co.uk doesnt work