General Discussions - 300ZX Related

hi guys hope you are all keeping well during this pandemic, (I will renew as soon as I start working again, being a full time dj at the moment sucks) anyway onto my problem, my front engine splash guard/ under tray has pretty much had it, it's gone brittle and split at the back by the radiator support, anyway don't seem to be any new ones around, so my question is, would the car be ok without it? and are there any available alternatives to them? I've seen the ally ones in the U.S.A but shipping is horrendous.

Hi, I know this subject has been covered numerous times but from everything I have found via the search has not solved my problem, car is a 92 NA and has a aftermarket actuator in the drivers door, when I operate the remote the drivers door locks but the passenger door does not. From what I have read there is a actuator on the drivers door lock that operates the passenger door lock when the key is turned either to lock or unlock, the aftermarket actuator performs the same action as the key and locks and unlocks the Drivers door fine. I have the bottom of the drivers side dash off, the kick panel off and the door card removed, If I have understood previous posts …

Did I miss something about selling on the forum has this been discontinued as I only see archived listings? Sent from my iPhone using Tapatalk

Soooo, on Saturday I decided to revisit my "alleged" groaning ABS pump - as per previous thread..... I have a spare pump, but before taking the plunge and swapping them out, I performed a few more tests - as the ECU diagnostic didn't reveal any faults. I swapped the relays - but the noise still persisted; I took the Zed out for many test-runs, Julia patiently sat in the back right seat, listening for where the noise may be coming from. We both concluded that it was probably from the pump - I had removed the plastic cover in the boot, just to be sure the groaning noise could be heard to the fullest. And then, I hit upon another idea - I removed the relays al…

Well new to me. Updated my original jap speakers to a more modern set from RichardS (thanks Richard) Door panel off and speakers changed over but of course I had to clean the inside of the door and the door air vents. Drivers door had been opened before for the installation of the remote locking and I had replaced the glass location roller thing. The passengers door panel was never of before and the plastic never opened. Any way here are the pics.

Congratulations to AndrewG for winning last month's competition. Submissions for this months competition are now being allowed if you all want to upload a picture or two. https://www.300zx.co.uk/competition/ As per last month you can upload as many as 5 of your best and vote on 5 of the best. If you were one of the winners or in the top 5 then please upload a different picture so that we have some variety to vote on.

What colour are the wires on the washer reservoir pumps ? are they blue and black? Which is -tive and what colour is the +tive? i have two new pumps to fit. thanks

Hi guys unfortunatly I’m not allowed to sell on here i have an original 300zx workshop manual hardback that I have decided to let go as you know these things are like rocking horse shit I have listed it on eBay but I wanted you guys to know about it first as o would like it to go to one of the club members if possible here’s a link , I’m not sure if it will work or if it’s allowed *** link removed ***

Just refurbished my wiper arms in satin black, now re-fitting the arms I would really appreciate if someone could post an image shows where the original rest position is. At the moment they are sitting right on the beginning of the black part of the lower part of the windscreen, but for some reason doesn't seem right?? A few images much appreciated:)

Spent ages today trying to work out why my washer jets were not working, started by filling the engine bay reservoir, still nothing just the motor buzzing..... Stripped out the N/S/F wheel arch liner, water bottle seemed ok, pipe at bottom nice and tight.... Then found another reservoir in the boot area... filled it up... still nothing but motor buzzing sound.... Then put air line on front washers, air pressure forced out apparent blockages.... front washer jets now working Also can someone confirm is the front reservoir for the rear wiper, and the rear reservoir is for the front wipers??

So when i dismantled the bottom end a few months ago i mistakenly left the crank exposed. Over the last few months its gained some surface oxidisation which easy came off with a cloth and wd40. Will i need to replace this or get is professionally polished again ? There is no pitting or scratches that i can feel although you can see discolouration in a few areas.

Can someone please list the LED bulbs required to convert the dash and both pods ? Many thanks

Hey Yall ? Not been active for quite some time but....... Recently been working on my almost a decade long project, nearly there, and the front indicators have no power to them. Harzards are fine both side and rear flash correctly, all bulbs working Indicator stalk side and rear flash quickly indicating bulb out, no power to front at all. I have replaced the front bumper, I have installed new larger side mount intercoolers. After spending time on the car on and off, basically I don't have a clue if I've missed anything. The ground is OK as its shared with the side lights and both sides light up fine. Has anybody any ideas please?? …

Guys, my aerial was working a few months ago but now seems to stopped working,i have checked the on wire goin to the aerial and there seems to be no power,guys is there a fuse for the aerial or does anyone know what might be wrong,Thanks

Lockdown blues is getting tome. Anybody getting failure on mot for Emissions! Article o 300zx-twinturbo.com shows dutch guy with meters on car showing high failure rate. He then disconnects small pipe to fuel damper and emissions were now passable!! I myself had fail on emissions about fifteen years ago, i removed pipe temporarily and it passed . I remove every time car goes in for mot and has passed every time! ! Ps don't forget to reconnect after mot. Even though car will run ok.!! Hope this is of some help to some one.

Guys i have 2.5 inch japspeed exhaust,but i was wondering where is the cheapest/best place to get decat pipes,Thanks all

Is this possible without removing the bumper, or is it just easier to remove the front bumper and get access?

Guys i have a question a few years ago,i got a few jobs done on my z,the mechanic said that the cats were bad on the car,78000 km on the car,At around 1,500 to 1,800 rpm while revving on and of the throttle i get a banging from the exhaust,it seems it coming more from the middle,would anyone know what this might be,And also it doesnt seem to idle properly,the car drops down to 600rpm and then jumps back to 900 then back down again,keeps doing this.I have uploaded a few vids sorry for the bad sound quality.Any light on the subject would be great,Thanks

Red twin turbo LWB, 1992 model, registered November 1992, has the Veilside bodykit which now looks horribly outdated... Auction Grade 3.5 but does suggest bodywork needs attention in a few areas but nothing major, is non-accident vehicle

Guys quick question,does anyone know if phutumsch,still sells the conversion kit for 300zx rear lights,if not does anyone know where i would get the parts?Thanks all

Guys quick question,how do i adjust the clutch?Also how do i know what slack(bite)there should be,Thanks all

hello does anyone no where i can get a pair of sills for a swb ? steve

Have seen a few companies selling these, eg ionic dynamics, interior innovation etc, etc Can someone guide who sells the best quality/ fit versions? Thanks

morning . the fuel pump on my convertible needs replacing . anybody removed the panels behind front seats to do this .?

Does anyone have any contact details for said company?