General Discussions - 300ZX Related

ASS HAIR I have recently made a mistake in my life, and I offer my story to all though tasteless, that you may learn from my error. It all started, as many things do, with me having trouble pooping. No, I was not constipated; this was not a regularity problem but a matter of technique. It seems my ass-hair had grown to such a length that tiny grogans were constantly getting tied up in the matted jungle between my asscheeks. It led to much frustration, with me KNOWING that I still had something to drop, but unable to shake the tenacious turd loose from its butthair dwelling. Eventually I would have to do two things: either reach down with somepaper and try…

Are you grinning? You're gay if you ain't!!! ROFL ------------------

I have had trouble with this TC since day 1. It has never worked correctly, well for no more than a few mins. My passenger front ABS signal is not being picked up. I have changed it to a newer one, with no difference. The ABS diag says nothing wrong, and to test if that was working, I disconnected the sensor and went for a drive. With in a few yards the ABS light came on and signalled no passenger front signal. So this means the diag is working and that a signal is reaching it from the front passenger ABS. This means that the TC is not getting the signal from the ABS unit. Which means either, A: Bad wiring. B: Bad TC unit. I am no genius with wireing but a…

www.300zx.co.uk/rides/mac_1/madbarbie.mpa ------------------ [This message has been edited by MAC 1 (edited 11-04-2002).]

Hi, I have had the steering stiffen up on me intermittently and the other day I was thrashing it, came to a corner and it became really stiff, it nearly caused me to change my undercrackers! I have heard there are speed sensors on the gearbox that can go, I have checked the PS fluid and that is full. Any Ideas would be gratefully received! Mark

Hi, Does anyone know where I can get wheel ramps that will go under the spoiler of a Z and will fit 225 wheels? All the Best, Mark

Blimey, I advertised my Supra on the GTO Site and I couldn't believe at the childish response I received. Bezerk! If you're interested then check out: http://www.gtouk.com/ Go to Message Board, Classifieds - For Sale, Supra For Sale Peter

Right, my gearbox has started to play up - it is a bit jerky between gears. Would this be a good time to purchase a warranty, would I get away with claiming for a box & anyone know any good places to get one from. Jay Edited due to dodgy typing ------------- [This message has been edited by JayPSC (edited 11-04-2002).]

Not fair, my flamegriller won't let me play with this! You guys can though! LOL http://www.animalinyou.com/survey.asp ------------------

Hi guys, Was bored at work so thought I would have a go at updating my rides section. The boss was away so could spend some time on it... http://www.300zx.co.uk/rides/deano Not bad though I think Cheers, Deano.

http://www.google.com/technology/pigeonrank.html ------------------

Hi all, I tried to run the auto diagnostics as advised yesterday, ignition on, into 1st, O/D off, depress accelerator and release - nothing happened :-( Am I doing it wrong or do I assume that the test circuit isn't working....? Cheers, RobH

for those who haven't met these chaps, their pics are transposed! Tim

can anyone tell me if there's somewhere on the internet where I can find out what the part number is for the top radiator hose (top left as you leek at the engine bay from the front) it's split and I'm about to limp to the local nissan dealer and really want to avoid the usual £25 fee to see if its the same part on my import as a UK model ??

I HAVE A 1990 JAP SPEC AUTO 300ZXTT FOR PARTS, ANYBODY WANT ANYTHING????. THESE PARTS MUST GO SOON, NO REASONABLE OFFER REFUSED!!!!!!!!! DASHBOARD x2 £75 each HEATER BOX x2 £10 each DASH HEATER CONTROLS £20 A/C BOX £10 AUTO BOX E.C.U. £75 A.B.S. E.C.U. £75 PASSENGER CLOTH SEAT £50 (FREE FAG BURN) DRIVERS CLOTH SEAT £100 BACK CLOTH SEATS £75 COMPLETE CLOTH TRIM £75 A.B.S. CONTROLLER £75 PASS SIDE E/WINDOW MOTOR AND REG. £50 PASS SIDE DOOR HANDLE £15 REAR JAP BUMPER x2 £50 EACH TARGA LIDS x4 £75 EACH DRIVE SHAFTS £50 EACH REAR SUBFRAME £100 REAR DIFF £400 PASS. SIDE DOOR £100 P/STEERING RACK £100 STARTER x 2 £45 each FRONT BUMPER…

And by that I don't mean XXX wants to kill XXX!. I have seen this on a couple of other forums and I think it's a good idea, everybody likes a good race story.

Guys, I've got here a set of 4 pulleys from Courtesyparts.com. The water pump and crank pulley are fine - but the alt and p/s pulleys are completely the wrong offset (arse). According to Bob @ Courtesy, the US Zeds have different p/s pumps and alternators - and they (possibly) don't do a set that'll fit the 1991 UK TT. Is this true? Will a pulley set from a different American model fit a 91 UK TT Z??? Any thoughts are much appreciated Cheers ------------------ Simon

Hi Guys, does anyone have or know where I can get a full set of wheel nuts and studs for my 1991 NA, yep all 20. Tyre people have progressively nackered all my studs and nuts and now most of them are always loose. many thanks, Amer.

Does anyone know if someone makes a turbo (psi) guage that would fit into the lower slot below the radio. I want one that has a black background and white numbers, a red needle to match the main dash instruments would be even better. I have a turbo timer and soon a boost controller so I think there should be just enough space for one guage by the side of them. Any ideas? ------------------ John Newcomb www.geocities.com/jn300zxtt

Sharp mpeg-4 digital camera for video and audio recording. Model number - VN-EZ1 Look at my Z pics in my rides section for quality of pictures. All boxed as new with 4mb smartmedia card, floppy disk adaptor including sofware worth £70, carry case and all manuals. £200 ono

I am considering not buying a 300zx now. I went to the Nissan dealership and they said that 300zx's are very expensive to maintain, they said that bearings would cost a minimum of £500!!! Is this true? I know a japanese import it would be expensive for part, but is it the same for a UK car??

Can anyone tell me how I paste in a JPEG image when replying to a message on this forum. I'm an I.T. Contractor by trade, so I suppose I should know really, but rather than waste hours working it out, I thought it best to ask instead. Thanks AndyZ

1990 RED JAP IMPORT 300ZX AUTO WITH LOW MILEAGE. Very clean throughout with a nice upgraded sound system, in-car boost controller, racing exhaust sytem (and possibly upgraded ecu) and turbo timer. Black leather interior and MPH dials. £5500 ono.

I'm having problems dowloading pix from my camera to my c drive. I can download to d drive though. I get the error message"cannot download to this location. Either the disk is read only, the selected device is not ready, or the disk is full" I used to be able to download to c - any ideas?? Cheers Vijay