General Discussions - 300ZX Related

Hi, Just noticed today when i was on the motorway, put my foot down and the power light didnt come on..seemed to boost ok, are there any instances when the power light wouldn't come on? comes ok from the switch by the gearbox.. thanks

OK I will be working on the car Friday and Saturday to resolve the safety boost limit prob I have. From the diagnostic I done a while back I found the following: - Pass o2 sensor knackered - Engine temp sensor - Harness and Connector OK first job is to replace this o2 sensor. I have the thing ready and will probably take me but an hour to do the job as everything is stripped inside the engine bay in the area as I ripped the thread. In previous threads it came apparent that the harness and connector and eng temp sensor probs were supposedly resolved by cleaning the connections on these. I havent done a diagnostic since, but I am still unsure if this…

G reg, Yellow Zed parked outside a house on or off Norton Avenue in Norton (or is it Billingham or Stockton) Was on my way home from work dropping some1 off at 6:15 am this morning. Anyone from here? Mrs djtomo

Does any1 know if theres any difference in the tailgate skin that Z centre sells and the 1 u get on http://www.300zxstyling.co.uk? Was just wondering if the Z centres fits better and easier or why it works out about £40 more expensive after VAT and P&P??? :rolleyes:

Grey Zed in Park Road Bromley, always driving past it on the way home from work, only seen it the last couple of weeks?

Has anyone on here ever done it? I did see a thread where someone was half way through it, but can't find it. Just wondering if anyone's done it successfully at all or not. I'll not be refurbing them. But would like to strip and rebuild them. Do they require gaskets or sealing upon rebuild? Any info would be a help. Thanks Si

Im going for 4 wheel alignment on Friday after ive fitted my coilovers but the guys at RSE Motorsport are asking if i have set them to 300zx spcific geometry :confused: I thought it was just a case of adjusting ride height anddamper and away you go.But apparently not. Can anyone who has coilovers help me with this one please? Thanks Steve.

Polyurethane steering rack mount bushes?-cba to check all the sites! :rolleyes:

Where do I buy a Strosek Wide Arch Body Kit from ? Any ideas how much the whole thing costs ? Thanks

has any one got a prop shaft for a turbo ? dont need the rear half or the support bearing , just the front bit . pleeze !!!!

Hi, My boost gauge sits on about 3/4 (or even 2/3) of the way in negative boost when idling, but all the way to -14 psi when I come off the gas when the car is moving. Should the gauge stay all the way over to -14 psi when idling? My revs are nice and stable on about 650 rpm. If so, is it an indication of possible problems with piston rings? I thought I read that somewhere. Bart

Hi guys i was wondering if anyone can help me? Well after 2 years of having my Blitz DSBC ive finaly got around to fitting it. The reason its taken so long is ive been waiting to upgrade my tubs and injectors.Well that day has come and i started it up last night.(jeeezzz it sounds mean) Anyway my question is can anyone talk me through setting up my BC as im a little lost,and i dont want to blow my engine after only just putting it back in. Even some settings which i can run safely. The spec is as follows. Nissmo 555 injectors Garrett GT28R turbos HKS uprated actuators Z1 SM intercoolers HKS induction Full Alunox X pipe decated exhaust system with div…

Right, I have just received these in the post, how the hell do I fit them? On my Calibra, I had a tee piece which went into the inlet hose that the valve went on to, but these ones dont have anything like that so any ideas?

Gunmetal Grey 300 seen heading into cambridge just past Marshalls on Newmarket Rd at about 1605. Was a G reg i think and had a big rear wing. Was it you? alex.

can you get a chip for a toyota camry 3.0 litre? m reg cheers

Black Zed going down Princes Drive .... near the bridge around 6pm last night so shocked I didn't react in time ...no idea number plate (god I'm so crap at this!) :rolleyes: I was the grey Zed going up towards Ford Plant/Blockbusters in a big hurry :) First one I have seen locally in ages Anyone on here?

I've finally got my car back after Ryan has nearly lost his hair with it. Boy has that man got patience - I thought he was going to charge me rent on it! I'm convinced now that the car is actually possessed - give it a re-con engine and new turbo's and it still laughs at me by splitting a top hose! But once again Ryan saves the day. So for anyone visiting ZTech lately, there's no more yellow heap hanging around - hope I've not spoken to soon. And to Ryan, thanks again mate - I love this car and yes I have washed it. Now for 1000 miles below 3k rpm, oh and fit some new temp/oil gauges, and fix the fuel gauge, central locking, new tyres, cure the squeaky…

need to get the cam belt changed does anyone know a decent garage near sheffield yorkshire.dont want to take her to any backstreet cowboys who dont know anything about the 300.... :confused:

Hi All, Just noticed , sometimes when I put my foot down (not to the floor) i get a sort of air horn noise (not as lowd!), sounds like its from the front driver side of the engine..just wondered if it might be something bad..!!

Saw you today as you drove past my work today "Comet" In Camborne - looked like you we're going into Halfords.... Black Z with big wing like mine and aftermarket wheels....

Red "G" Reg standard Zed spotted in Wanstead this morning. Was it you? :)

hi guys,i done a search but didnt really find much,i just got an rps flywheel and rps organic max series clutch fitted to my car,it slipped once on the day i picked it up and now just slipped again 4 days later,ive tried putting it in 5th at 50mph and flooring it and it doesnt slip,any ideas? my spec is below if it helps thanks in advance Paul

Anybody got a linkor diag for the ECU, showing allthe pins and there numbers/colours. Many thanks Neil

Does anyone know what this bodykit and alloys are called ? Also is the spoiler part of the kit or separate ? Any ideas where to source these ? Thanks !

guys is it just me or does this forum no longer tell you how many posts you've submitted, it was there before but i cant see it on anyone's now? Obviously not a big deal just wondered if my account is screwed cheers. Dan.