General Discussions - 300ZX Related

Only £50 plus shipping!! http://cgi.ebay.co.uk/JDM-Nissan-300zx-kouki-spoiler-wing-fairlady-Z32-new_W0QQitemZ350003190136QQihZ022QQcategoryZ33638QQrdZ1QQssPageNameZWD2VQQcmdZViewItem

Well after installing the Doolz, my car hasn't taken a liking to it at all?? Despite having the SAFC controller and running it rich it doesn't seem to run at all well and struggles to rev up? Have others had the same problems and what needs to done to get it right?

front shock boots. passenger side has split. Where do I get them from and how much are they cheers :duffer:

Hi guys i am currently rebuilding a engine twin turbo 1990 after i brought a car with head gasket failure and i am wandering can i remove completely the EGR contro valve at back of engine along with all pipework if i block it off.Reason is ive brought some stainless decat pipes and they have no option to put these into them.

Anybody else having problems loggin on to this,followed instructions in email and keep getting invalid login message

Hi Im about to rebuild my alloy 300zx front and rear calipers , but the flat o-rings didnt came with my rebuild pack ?! what now ?! my local Brake center and Nissan dealer couldnt help me , asked my local o-ring shop and they couldnt help me either ! Are im screwed for a .20 cents o-rings ?! :shock:

anyone one in london can fix the inlet gasket will pay

Hi Guys.. Well.. After having my specially made number plates for just over a year now (bought from a guy on here) without the blink of an eye-lid from the authority, today was the day that changed :(. I got pulled over for the following reasons: 1. Non British Standard Front Number plate 2. Non British Standard Rear Number plate I was given a warning and 14 days to change the plates to meet the British Number plate standards which isnt too bad as i could have got fined. Here's The Car: After having checked the current sizes of my Character Height, Width, Stroke and Space between characters there was only one requirement that was actually le…

there is a guy selling a z32 maf over here, i want to buy it as i think mine might be a bit iffy, but how do i know his one is ok, anything to look out for, its a good price, i think £60, any help appreciated

Thinking of replacing the standard steering wheel on my JDM TT AUTO, but want an aftermarket wheel WITH CRUISE CONTROL buttons... Anyone know of any - any one got one? anyone know where I can get one? any of them good? Any I should avoid? Any pics? Thanks in advance, boys... and gals... :smw: P.S. Would love a wheel that looks like Jay's but with built in buttons...

Just spotted this - can't decide if i like it or not, what do you think?..... (Si i know your not going to like it - that's a given! :rofl: ) Ebay rear bumper

The reliability of my digital clock seems to be getting worse and worse. I have done the repair on twinturbo.net and it was ok for 6 months but now it is going down hill. Is it worth replacing the resistor and trying it again or is always going to be FUBARed? How much do you charge for a 100% working clock? Will one of yours work forever?

Ok this is a difficult decision and i just want to see if its normal. New heavy duty clutch put in around 9months ago!Clutch has done about 3kmiles and not alot of raping it. When in traffic in town the pressure of the clutch becomes pretty heavy sometimes and becomes really twitchy at the biting point. also quite often in 1st when pulling away the clutch will squeal if i dont give it alot of Accel. Iv been informed its the pressure plate and its not big enough perhaps and its just the air squealing through. Is this correct or should i be more concerned about it than that?? As been told hefty job as they need to take the clutch out to get to the pressure plate…

ok i fixed the idle prob, was obvious coz of the leaky clutch booster so i just blocked the vacume pipe, another bodge until i repair the booster. BUT NOW AAAAHHHHH the door open warning light stays on constantly even tho the door is shut and if the door is open the warning light gets brighter, this in turn has disabled my stereo and interior lights, if i switch on one of the read lights they give out a tiny amount of light for about a second then nothing. if anyone has had this same prob plz plz help as i have enough problems already. :confused: :confused:

Its a total show car and I wouldnt want to be seen dead in it driving down teh road, but you got to respect teh workmanship gone into that car. loving teh interior, but not the color.

I have a small active sub (blaupunkt) that I want to put in my boot, is there anywhere in the boot I can take power from that will handle it or will I have to run cables down from the battery? Thanks Dan

just to let everyone know guvnors other half had a baby girl yesterday. weighing in at 8lb 6oz. They have called her lilly. Both mother and baby doing well :-) Congratulations to them both

White Zed seen driving down Gathurst Road from Orrell, Wigan about 4 this afternoon. Looked like an import judging by the front plate and looked standard.

Was heading down West Swindon at around 4:30 today and saw a black Z with one headlight out. Thought I saw hima few weeks ago too (presume its the same Z as its the same headlight) :) Anyone here as I see so few about?

could any one tell me the bhp of my z when a print out tells me it is putting out 247 kw at the wheels.

Ok, I'm sure you all remember me asking about ECU remapping. Well I just got hold of the previous owner but one for my car. I turns out that when he sold it, it was running perfectly and at about 380-390bhp the car was chipped by a specialist firm all the paperwork was supplied to the previous owner. I haven't seen any of it. The owner (Adam) said there was a box under the passenger seat which is not there now, so it looks like the arsehole(Mariusz the guy I bought it from) has removed it or one of the shitty garages he took it to did. So heres the thing can I just go out and get a sports chip as all the extra hard work should have been done and get it installed. Ac…

as above was parked outside a house just outside of cudsworth barnsley i cant remember the village but i think your reg started with A12 ***

ok last thread for now im sure people are getting annoyed with all my problems. I want to remove my standard spolier as the paint has all cracked, how many holes will there be behind it that i will need to fill in?

Hey all, Anyone out there got any usefull tips i should know while my car is off the road for the winter & garaged till March? This is the first winter i've done this and other than the obvious of disconnecting the battery and leaving the handbrake off so the rears don't seize, what else should i do? Also, as it's due an oil change i was thinking about dropping the sump off next year (before i start & move it) draining it all off, replacing the sump gasket and topping up with fresh oil & filter? Any help or advice greatly appreciated ;) Cheerz James