JaiKai

Mind there's JAE next year too, plenty of time to get prepared !! Lol

Few of the concorde as i was very chuffed at seeing her ! All in it was a great day and drive up there and back !

My Turn, heres just a small sample of pics i took !

I thought it was his ! or isn't it ?

The guys names archie, has been a zed owner for some time and thats his seventh zed; also he's had that for over 5 years, but its mostly in a garage lock up i think.

Just like this !!

Hi, Its a small world ! My younger brother sent me this pic of a black zed which at the time he told me he just purchased - lying bugger - turns out it was another zed owner in my area. So I told my brother to stick the guy on the phone to see where he stays and when he got his zed - turns out he stays in troon and less than a 1/2 mile from were I stay. He's a member on here although not been on much and I cant remember his forum name - anyways getting chatting an i mention this show we're all meeting at, after a we chat I'd thought i'd invite him along - one more zed the better I say! so looks like we both will be driving up togther tommorrow morning for the 8:30 meet. Anyone on here recognise the zed ?

if your no bothered I would just cut, solder then heatshrink them again for a profesional looking job! I did this with mine !

Mee too !

Yip, and when's the last time you went to JAE???

The bezel on my Guages are about 5 - 7 mil. The diameter for the hole needed for the guages is 52mil which is the the height of the gap in the lower din slot - so no room for a bezel unless your Guages don't have a bezel, if not they Would just slide out or in through the hole made to hold them.

You'll have a tough time fitting Guages in there unless you do the same design as it's exactly 52mm in height! That leaves no room for the guage bezel, that's Why it's fitted from behind the centre console as from behind there's lots more room. On mine I glued the plate to the centre console and fitted Guages inside then pushed full console part including Guages into place !

Just remember the guage mount from z centre is recessed! The gauges actually sit behind the holder, there is a 2mm lip Round the plate that fits from behind the centre console then Another plate fits behind the gauges! The holes you see in the plate are smaller than 52mm and Are only ment to see the gauges through as below ; Face plate. ---/..../------/..../--- Guages. :::: :::: :::: :::: Back plate. /..../-------/..../ That's a side on view !!! (if it shows right)

Think it's just slightly narrower than a normal din slot !

And 4 mil thick!

Mine is exactly 186 x 57! I've got a two guage and a three guage type !

Yehaa !! Melting with Gass !!

Rather that than electrocution !

I've got small gas blow torch which i'd likely use in the way ! would melt it all in 10 minutes !

Likely will be if its easy enough - I do like the bling and dont want to lose it.