hellraiser

I have tested my injectors today and found no 1 to be reading 78 ohms! The others are 10.2 (9.7 taking into account the dmm lead resistance) only trouble is is I cannot for the life of me get one of the damn screws undone!!! Do I need an impact screwdriver?

Welcome back :-)

I have a very similar problem, according to datascan all is ok but I still have the problem , swapped tps, ptu, mf to no resolve. New plugs etc, gonna do a boost leak test next step z world. I watch in antisipation

If you need to look at a bell housing off of the car for ideas I have two in my garage buddy

255 45 18 rear!! your speedo will be out with those specs the usual tyre choice is 265 35 18 ! the tire height doesnt look right to me. fronts are a bit low on the wall height too.

What diameter are they?

Hahaha reminds me if the film white chicks

Also check the front pipes behind the aluminium hard water pipes , it might explain the staining on them

Nice work!

Eastleigh is a good track, been there a couple of times

I have tried to bring up some topics which I thought needed more responses on. jeff, one of them was about the ignition relay you covered a few years ago, I was hoping for you to respond back on that .

Looks tidy, welcome to the club :-)

Your beard probably weighs that, go have a shave before japfest ;-)

Another thing I have tried is test my coil packs resistance. According to the manual it should be around 0.7 ohms I was getting readings between 1.2 -1.5 ohms any advice on that?

I will give it a go, thanks :-)

Thing is my idle is stable, revs up like it should when cold, comes down to a stable rpm when warm. The iacv won't cause a miss fire as far as I'm aware

I put some new plugs in the other week, this was part of my problem solving. Iacv I haven't tested as yet but only cleaned it a short while ago, will pull out and clean and test again

Because it runs like shit for the first 2-5 mins then clears .... This happens everytime on a first cold start up.

I checked mine tonight and it's fine so not my problem.

Large fuse box engine bay labeled ign coil, green relay

Humm interesting, gonna check mine out as I have an intermittent misfire somewhere

Jeff are you still working on this ?

It's a black box, hung vertically , approx 6 inche's by 4 inches. Drivers footwell on left hand side, tucked next to the clutch pedal

Fank ooooo guys :-)

Happy birthday fella :happybday::happybday: