Anthonyd

That's cos the standard gauge is sh1t :whistling::whistling: Mine sits at normal when the aftermarket one is nearly at 100 degrees C

I had one for three years and never missed a beat or failed the mot, just make you follow the service schedule. Mine had 225k when I let it go, only issue was the duel mass flywheel going but after 100k in three yearss thats not bad! And it has chipped and when like a rocket!

Two cells on ground floor complete with 2 inch thick wooden cell doors!

Yes, just round the corner towards talywen rfc. Will pm Thursday, if you about it would help alot.

Well after 2 1/2 years on the market we have finally exchanged contracts today :hyper::hyper: So next Saturday we are moving to the new place, no garage but will build one but it's a massive house that used to be an old Police station!!! So bye bye chavsville and hellow 4 bed detached spacious house!!!:clap:

Moving in on Saturday 27th if your free?!!

Going to get it mapped for the single tub set up to as only on a base map at the moment so massively overfuelling I think as sometimes won't start as flooded!

Fingers crossed Talywen, Garndiffaith.

Anyone work at Tenneco in Brum, grey Z in the car park?

It's running and in weekly use at the moment, until the rad split but hopefully sorted this Friday. I do need to get to Mr Dixon before Japfest for a mapping session with the Q45 MAF fitted. I have been a little slack lately as have a new job and just selling the house and buying a new one in Pontypool so won't be on here much for a few weeks until we're all sorted with the new place.

I will more than likely be going so we can organise a convoy. I did try to arrange several meets last year but there were no takers. Maybe this year we'll have more luck! I'll be in the single turbo!!!

Alot cross over to the n/a but sfs never got time to list the crossovers, Luke has done it though http://www.zcentre.co.uk/shop/index.php?cPath=21_84

They have loads of 300 kits and do the vacuum hose in purple.

Yes, no problems

2 core no earth

Downstairs- Black is 12v Red is 12v Blk/Red is 0 Upstairs Red is 12v Black is 12v Red is 12v So what goes where, switches both have 1 way 2 way Common

I will have a go now but to check A red and black joined downstairs along with a red and black the red is 240v in, one way black is 240v switched wire two way black/red common?

SFS Performance will do them in purple for you.

I now have a test meter, do I need to check each wire with thetwo switches off as they obviously switch between 12v and 0 depending on the switch positions.

No problem, was hoping it was a common set up in older houses. The best I can tell is downstairs switch A red and black twisted together from the same cable, then a separate cable with red and black. Upstairs switch A black and red from the same cable, then a red on it's own.

Thanks! :2guns::slap:

I have 4 reds and 3 blacks A red and black joined downstairs along with a red and black Upstairs 2 reds and a black We can get the light to work downstairs with the switch in one position but when we switch upstairs it the doesn't work! Switches have on the back One way / 2 way / common

As above anyone on here offer some help with a two way light switch?

About this quick! http://www.300zx.co.uk/forums/showthread.php?t=133537&highlight=single+turbo

All done and very quick!!:ph34r: