General Discussions - 300ZX Related
Z related topics and discussions
79,726 topics in this forum
-
Morning all, noticed my zeds starting to smoke pretty badly, if window is open and your sat in traffic you sorta start choking on the smell. Notice a puff if your boot it - throttle off then touch the accelerator again. Im thinking its turbo seals but would that cause smoking under fairly normal driving??? If it is turbo seals - any idea on how much to get them replaced? Cheers
-
- 5 replies
- 410 views
-
-
hi all. just a quick question for those who know... will the N/A manifolds (or aftermarket ones for the N/A) go onto a TT head? i know there wont be anywhere for the turbo to go, etc.... just wandering if they bolt up? im upto something if it goes well. :hyper: :rofl: cheers si.
-
- 0 replies
- 256 views
-
-
Hi pep, just wondering if i could get some help on this matter, im finding it very hard to find general info on my 300zx, ie lengths etc. The problem is i need a new boot lid for my 300, its a 2 seater swb and i was wondering if a boot lid from any 300 will do to replace it? If anyone could help or has a boot lid that would do the job i would be very grateful.
-
- 13 replies
- 738 views
-
-
Hi, I was on my way to work this morning when a silver Z passed me on Torquay seafront. Female driver ??
-
i have a greedy profec b 2 boost controller but when i set it to hi i get a boost spike to about 16 psi and then it drops to about 14.5, how do i cure this? i want to run about 15.5-16 psi with no spike the settings im using at the moment are set = 33 Gain = 21 set gain = 85 warning = 165 drop = 20 cheers in advance!
-
- 8 replies
- 612 views
-
-
Hi guys does anyone know where the neutral switch pin is on my ECU as im doing a Auto Manual conversion. And do i just cut the wire and ground it? Thanks Steve.
-
- 24 replies
- 3k views
-
-
Spark plugs!!!!!!!!!!!! What do i go for? Hotter, colder, copper, iridium or influx capacitors FFS :rofl: . I have read many threads and the time has come to start winter maint, with the plugs being the first on the list. Im running the Zed on a boost controler, chip and filter. Thats the only engine mods so far. So whats the latest then LOL. Look forward to seeing what everyone is running on ;)
-
- 9 replies
- 592 views
-
-
I NEED TO NO HOW TO UPLOAD THESE PICS TO RIDES SECTION, CAN ANY HELP??
-
- 4 replies
- 294 views
-
-
anyone got these ? http://cgi.ebay.co.uk/Nissan-NISMO-Black-Floor-Mats-5PC-200SX-S13-S14-300ZX_W0QQitemZ8028401380QQcategoryZ36678QQssPageNameZWDVWQQrdZ1QQcmdZViewItem Any good ?
-
- 5 replies
- 297 views
-
-
thinking about getting a pair of slick tyres for the pod, can anyone tell me where and how much? Yas
-
- 8 replies
- 539 views
-
-
I own mattys old zed whcih is a nice car with 99 spec rear lights .. a while ago I lost the use of sidelights (and all associated systems ie rear lights and dash lighting) but the headlights worked fine. Of course it was dark and I was in a contra flow with the feds a few cars behind so couldnt limp home. Phoned Mr rac and he came out and after farting about for 20 mins found an aftermarket relay fitted into the sidelight system that had stuck in (what he said was on but clearly he meant OFF) position. He disconnected the power to the relay it clicked and then reconnected it and it worked. He swapped the relay and of I was on my way. Its Happend again, (at l…
-
- 14 replies
- 529 views
-
-
Hello, never had a 300zx so is there a few things i should look for particularly. I have a choice of three : 1990 300zx import 31K mileage TT - auto - 3700£ 1991 300zx import 62K mileage TT - auto - 2700£ 1992 300zx import 55K mileage TT - auto - 3200£ My gut feeling would be to pay the extra and get the older one with less mileage, but i have read that the 1990 were prone to a few more faults than the later models. I have not seen any of thses yet as i am flying from Ireland to purchase one on Thu 12 Jan. So the usual checks you would do on any car applies, I am looking for specifics if that is possible. Maybe stuff that should be looked at in alot…
-
- 9 replies
- 609 views
-
-
This may be a stupid question to ask, but how would you know if your water pump has packed up?. I know they can start leaking which is obvious to spot, but that wouldn't stop the pump circulating coolant. How do you check that its still pumping the coolant around the engine, leak or not? Cheers...
-
- 4 replies
- 1.9k views
-
-
I was in a Black one and you were turning into South Croydon Station
-
why my Z overfuels, I start the car, put her in gear almost instantly, drive a few yards, switch her off and then the next time she wont start untill I crank her for 5 mins and all the smoke puffs out the back. Only does this when engine is cold and switched off befor it gets warm, when I leave it to warm up for 5 mins and do the same as above, it's fine.
-
Hi guys Only picked up my 300 on Friday evening so I've had it less than 4 whole days and already the questions are piling up ... Been on the forums for a while as always wanted a 300 since joining the Z ownership ranks nearly two years ago with a 280 ZX but have now treated myself to a Twin Turbo and need as much help as I can get here goes 1) The car has no rear badges at all - and only a Z badge on the front - it has the 300 ZX rear lamp section and 'Fairlady 300 ZX' mats in the front foot wells - I was told it was a 1992 Fairlady Twin Turbo - should it have rear badges - have they just been taken off by a previous owner ? 2) Reversi…
-
- 17 replies
- 734 views
-
-
On Monday driving torwards hospital. I was in a white van flashes my headights.
-
- 0 replies
- 366 views
-
-
-
I need a bit of help,i have Blitzs bov on top,how is the proper way of blanking of the old ones?????Cheers
-
s my front bumper standard as i have seen many looking standard zeds with a slightly diff bottom to the bumper, is this a difference with year, jap or uk?
-
- 14 replies
- 490 views
-
-
can anyone tell me anything about these Alpine bit's and bobs? First one is TVE-T006 second one is NVE-N055Z don't really know what they do but they were in the boot of my Z when I bought it and I put them in the garage and forgot about them. The TVE says something about being a TV tuner and the NVE doesn't say anything on it. I get the feeling they were jap only cuz I can't find anything about them in english.
-
- 0 replies
- 304 views
-
-
Hi Selling my 300 on e bay at the mo and a potential buyer has asked me the engine number. Now I know its at the back of the block, and like everything within the engine bay, will be a sod to get to or see. But can anyone show me a diagram or detailed description of wher to look? Ive been outside with a torch for an hour and no luck! Thanks Karl
-
how long does a driving ban stay on your licence for? i know points come off after 3 years but you have to wait an extra year to have them removed from your licence.
-
- 15 replies
- 625 views
-
-
It's the bearing in the front where the kingbolt enters. Is it possible to just replace the bearing? Called Nissan and they said that I had to replace the hole part (the leg or whatever it's called)
-
- 1 reply
- 329 views
-
-
i have set a picture as my signature picture, i can see it when i post but no1 else can. in the options i have selected to show my signature. HELP!
-
- 14 replies
- 361 views
-