General Discussions - 300ZX Related
Z related topics and discussions
79,696 topics in this forum
-
Hi all I've not long ago aquired my first Z (TT auto), I managed to buy a manual for it but find the info I'm after either very hard to find or to be non existent in the manual. Maybe some of you more experienced Z owners can help. a. windscreen wipers, what size do I need (front and rear). I think the rear one fitted at mo is too small. b. tyre pressure c. oils !!! (I know there seems to be a bit of a debate going on about engine oil, but what about power steering, brake fluid etc) d. anti freeze, what % to parts of water Thanks in advance Ern
-
- 3 replies
- 274 views
-
-
Guys, Ive had some probs with the electrics lately and i had to pull some fuses out to stop the horn going off etc etc. Anyway, i had to remove one of the headlight fuses as it that also got affected. However when i did this i notice that if i turn my lights on now the small round ones come on as well as the main beam ones on normal driving. Now i noticed that the main beam (square) lights were in fact dipped. Now i didnt know they could operate in a dipped mode, i thought they were for main beam only....am i right in thinking that the small round ones are driving lights and the Square ones next to them (in the same unit) are for main beam only?? Or sh…
-
- 6 replies
- 531 views
-
-
yesterday @ 3pm...going south on the A23...me in the red Jap TT of course
-
- 1 reply
- 286 views
-
-
hi all just wundrin, i need to take my car in to zedworld when ive stumped up the cash, say 4 weeks or so, and i think im gona need the following done; 1.main crank seal (back) 2.cam belt + water pump 3.leaking high pressure hose to power steering pump (or at least it think thats where it coming from!) 4.strong smell of fuel think its coming from where the supply comes from undernesth the chassis up to the fuel filter. Does anyone know how much this might set me back est. or has anyone had this done and already know how much its gona be any replies gratefull guys!!!! :)
-
- 6 replies
- 348 views
-
-
Where would I plump an oil catch can into in engine bay.To what pipes? It has one in and one out.Any help would be appreciated.....Vinz :bow:
-
- 10 replies
- 1.1k views
-
-
Hi All ! I just want to know if the 300zx NA FRONT & REAR STRUT BAR fits on all 300zx Model (NA, TT 2seats, TT2+2 seats) , or just on the NA model... thank's :)
-
- 14 replies
- 722 views
-
-
Hello guys, My car has just sailed through it's MOT thankfully but I need to change the oil at the weekend. I am going to save some money on garage bills on the basis that this should be about the easiest piece of maintenance. Experience tells me it wont be that simple on a zed - are there any pitfalls? I looked at the technical site and they said I should use a filler cap socket - is this necessary? Finally, I have looked at the discussions about synthetic oils etc - can I get these at any spares shop or do i have to find a specialist stockist? Thanks for your help.
-
I read somewhere that the first genaration z31s 300zx had a clutch pack type lsd instead of the z32 viscous type i know these diffs are better than the standard z32 viscous type does anybody know if they will fit the z32 or will the internals fit in the casing.Clutch type diffs are good for drifting the AE86 corrolas have a clutch type diff as standard as well.thanks taff
-
- 0 replies
- 227 views
-
-
Car cost : 2900 Peace of mind ( Belts and water pump ) : 330 +vat Remote central locking fitted : 75 ! years Tax : 170 years Insurance ( this is the freakin good bit ) : 234 fully comp from carol nash :bow: Smile : still there from the test drive, cant wait to pick it up on sat :hyper:
-
- 10 replies
- 431 views
-
-
got back from zedworld today had my worst fears diagnosed one of my turbos has had it also turn s out sitting here with a receipt for a cam belt changed 4000klm ago dosnt look as though its had one +other faults that will teach me wot a bummer help :o
-
- 5 replies
- 480 views
-
-
Garret T04 turbos will these fit and if so wat mods will i need to do.
-
I want to check my timing as i think the car is over fueling due to a strong smell of fuel from the exhaust, the car is a JDM TT Auto, been looking for a right up on how to do this on the Z but cant find one, i'm used to working on older cars and am not sure if there is anything different about the Z, any help much appreciated, Dave.
-
- 11 replies
- 704 views
-
-
I went to the local Tesco 24 hour supermarket and to the petrol station and asked about 99RON fuel. I might as well asked for asked for enriched plutonium, the old dears did not have a clue. Is there anywhere around north east birmingham that i can get my mits on Tesco 99 RON fuel. And is this better than Shell Optimax?
-
- 2 replies
- 332 views
-
-
As you may well know, I have just fitted my new Koyo rad but since then my air con takes ages to warm up is this normal?
-
Once it is confirmed you will be receiving a week’s ban for starters. :rant: Causing problems in a sneaky under handed way for the Committee won’t be tolerated.
-
- 4 replies
- 241 views
-
-
on my private runway ofcourse :mac1: right then where to start?? i have had a new engine fitted it was a manual engine but im sure there is minnimal diffrence bettween auto and manual tt engines anyway, because its got all new pistons and bearings in the engine i have'nt been able to over rev it for a few thousand miles, :D fitted a hks alc :hyper: finnaly had a chance to floor it after running it in for 2500 miles everything fine till 125mph then i would hit the rev limiter and no gear change :rant: so i thought it was the alc, i removed that and tried again, still no gear change above 125 :headvswal so i double checked the plug in…
-
- 9 replies
- 526 views
-
-
Is the standard one electrical or mechanical?? Mines not reading correct (what should it be for a jap TT?) Its all over the place. Would it be the sender or the gauge??? Or shall I put in an extra oil pressure, temp and boost gauge somewhere else?? And how the hell do you do that?? lol. Electrical or mechanical?? Anyone near Southampton thats done it???
-
- 9 replies
- 576 views
-
-
-
need to get a replacement engine for a toyota avensis vvti 2001 model any ideas where to get a low milage replacement or any idea on pricing ?? help
-
- 3 replies
- 297 views
-
-
Ok, so I've got an uprated ECU which is currently running JDM fuel mapping....Circa 100RON. Now, I know it's detremental to the health of the engine running a lower grade fuel (super U/L), I am hopefully getting a new chip this weekend...from Mr Dixon if all is well and good. I don't drive my Zed hard, infact, I don't keep it on boost for anymore than about 3 or 4 seconds and I don't boost it that often anyway. It doesn't get used much and I think I've only done a few thousand miles since I've owned it. So, it shouldn't really have effected the engine as if I was to have been driving it hard? Just wondering really. John Dixon chip on the way, so all is good…
-
- 5 replies
- 314 views
-
-
Had the car parked up in the driveway on axel stands at the pasenger side as the wheels were away getting re furbished and got the wheels back yesterday and the car wouldnt beep open. I used the key and when I get in and try and turn her over absolutely no power or lights coming on! Bout a week since I had her started but battery was totally fine. All the wires seem to be ok and the car hasnt actually moved. Only my mate that took the car of the axel stands. Any ideas of things that could cause this? :headvswal
-
Hello guys, Have a set of the above spark plugs about to fit in the car. Have read some previous posts and there seems to be a mention of altering the gap on the spark plug. Can anybody with these plugs please confirm if this is the case or can they fit straight in. cheers ronnie
-
- 3 replies
- 432 views
-
-
Just would like to know if the HKS drager 2 exhaust only has a singel tip or two?
-
- 3 replies
- 329 views
-
-
I have my ECU being socketed and chipped followed by installation of a Greddy Profec B II boost controller. Once these are in I will obviously need to upgrade my boost guage and oil pressure guage to aftermarket. I am hoping to order the A-Pillar pod which only requires 2 Guages (still not sure where to get it from). I have looked at fitting guides for both installing a boost guage and the A-pillar pod and its still a bit unfamiliar but Im sure that once I start it shouldnt be too bad. Still cant find one for oil pressure though :cry: Does anyone else have any useful tips of how to fit or is it worthwhile getting someone who has done it before t fit it. Also I…
-
- 3 replies
- 362 views
-
-
Front page of Somerset Gazette, picture of White 300zx with series 4 spoiler. A suspected drink driver in a Ford mondeo had lost control and careered through three gardens and into the zed ! :headvswal :eek: :(
-
- 4 replies
- 423 views
-