General Discussions - 300ZX Related
Z related topics and discussions
79,698 topics in this forum
-
If anybody is intrested in suspension tuning i out a bit of a tutorial up in the faq's http://300zx.co.uk/forums/showthread.php?t=95683
-
- 0 replies
- 320 views
-
-
Can you get a top tint front screen for the zed maybe a bronze /bronze or a bronze/ blue .Im sure ive seen them before .Did uk cars get them as standard i know uk cars have blue glass .thanks taff.
-
- 2 replies
- 318 views
-
-
According to datascan my water temp is 110c !!!!! the temp gauge on the dash stays in the middle. I have recently cleaned the temp sender as i was getting code 13, i get code 55 my question is if the sender is not faulty what could cause such high temps? I will buy a new sender & try that
-
- 3 replies
- 537 views
-
-
hi guys n gals just a quick question. i have a loudish whurring noise coming from my gearbox when i have my foot on the clutch especially when the car is cold. pretty sure it's the release bearing but my question is can i just replace the release bearing or should i do the whole clutch? cheers alex
-
- 3 replies
- 437 views
-
-
Hi, i have been searching through previous posts but couldnt see a full answer for this (although I apologies if this is because of my ignorance). I seem to be hitting a "wall" when accelarting through the gears. I am still getting used to the car's full capabilities and have taken my time in easing it in (since having a recoditioned engine put in). I have done all the recommended mileage about 4000 miles of it with the upmost care and have spent another thousand opening it up slowly. 1 for the fear of damaging it and 2 for the fact that it has an awful lot of power anyway. But now I am trying to gauge it's full capabilities it stops at 3rd gear - 6200rpm and 4…
-
- 6 replies
- 458 views
-
-
Im thinking about putting 2 dumpvalves on my Z,, are these hard to fit? ive located the blow off valves but seems like it will be hard to get to them. :confused:
-
- 3 replies
- 411 views
-
-
As some of you know I use the US 300zx forum and I'm quite into the whole US Z scene in general. Anyway, Nissan Sport Magazine USA have just run a competition for this quarter's edition and my car was chosen! So, not sure if anyone in the UK gets the magazine, but photos of my car will be printed in the summer edition! How chuffed am I!! :hyper: :duffer: :D :smw: http://www.nissansportmag.com http://www.myspace.com/nissansportmag
-
- 23 replies
- 1.5k views
-
-
For anybody who is thinking of doing this job have a look at this site http://forums.freshalloy.com/showthread.php?t=162693 Done to a 240sx and a very good write up hope that helps someone
-
- 12 replies
- 459 views
-
-
-
-
Ive got it installed but all the settings are off so need someone who knows what they are doing to help me set it up as ive heard it needs to be done while driving. A few :duffer: tokens of course to say thanks :D
-
- 22 replies
- 1.6k views
-
-
For setting the old gubbins up for me, keep me posted if you find that conflicting jobby!! :hyper: :hyper: See, who says I dont know fook all about computers??? :headvswal :headvswal
-
i have just bought my tt is standard apart from twin exhaust and air filter but i seem to be getting detonation when at full boost in second and sometimes third im also finding that the car is going into safety mode and restricting the boost but is fine mafter i switch ignition off and on any suggestions would be appreciated thanx
-
- 4 replies
- 441 views
-
-
i know this has been done to death, but i wondered what my car was worth if i was to sell, no silly replies, im just fancying a change, prob wont ever sell but i might, who knows below is a list of whats been done, but if i was to sell i would add tein coilovers and a 99 spec bumper, im sure dont need to post up pics as most of you have seen my car MODS SO FAR JWT chip Scorpion stainless steel exhaust Blitz SUS power filter Decatt exhaust smithys RPS street clutch Fidanza lightened and balanced flywheel Pace large side mount intercoolers Apexi twin chamber blow off valves 340 fwhp 261 rwhp (Proven) BODY WORK SO FAR Paul Bailey wide arc…
-
- 19 replies
- 1.1k views
-
-
White Zed on Axle stands, didn't look very well :( anyone on here?
-
- 0 replies
- 205 views
-
-
9th @ 7pm, Spotted a white 300zx full of lovely lookin ladies coming out of Margate! ;) You would have seen 2 silver z's coming in the opposite direction... hard to miss ???????????????
-
I know it's not strictly in the right section, but it's a technical question rather than general chat!! Basically, my brother in laws parents have an S Reg Corsa and the alarm's playing up - going off randomly. They're in their 80's and the garage are trying to charge them £400 to replace the unit. I've had a scout around the internet and it seems that the 'powersounder' in the n/s wheelarch has an internal battery which, when it fails, causes the alarm to trigger. There's supposed to be a way of replacing the battery itself, but if you damage the unit the car will auto-immobilse and need to be reset with the vauxhall diagnostic tool. So... does anyone kno…
-
- 5 replies
- 451 views
-
-
Evening all Just driving back from work and this red warning light started flashing at me, mainly when I'm slowing down. I havn't got a manual so any help would be appreciated.
-
- 5 replies
- 497 views
-
-
Hello, am sorting out doing some work on my car, the engine is a 1995tt; the transmission is auto and the body 1992. High on the list is replacing the engine wiring loom. I understand that the wiring loom is no longer made for this year, and not possible to get new. Thus, I am wondering what my options are. What exactly are the differences between the years? for instance I can find a new 1993ttauto loom. Is it worth putting in some aftermarket coil packs like Splitfire's offerings, and changing the injectors to a loom which is available? I know that plug replacememts are available, however I really do wish to replace the entire loom from the ECU back. …
-
- 1 reply
- 315 views
-
-
My latest car I am told is fitted with an AB Flug front bumper and the side & flasher light assemblies are fitted behind it with a plastic lens screwed in front to make it look better visually. To change a bulb is a nightmare, i.e. remove bumper which as you know is not a 10 minute job. Does anyone know what lights would fit in the aperatures provided that could then be removed from the front without having to take the bumper off. :(
-
- 11 replies
- 715 views
-
-
Love the look of this Fat Ass Who's Is it and does anyone have anymore pics of it
-
- 3 replies
- 421 views
-
-
Is the TT fuel pump is a bosch, and what is the bosch number? Is it rated to 255lph? I have a NA Fuel pump and a NA fuel controller will the TT units fit "bolt on"?? Do I have to do modification to make it fit???
-
- 5 replies
- 558 views
-
-
Has anyone any experiance/ recommendation of these clutches ? http://cgi.ebay.co.uk/NISSAN-300ZX-TWIN-TURBO-FAST-ROAD-HEAVY-DUTY-CLUTCH-KIT_W0QQitemZ260127257042QQihZ016QQcategoryZ10402QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
-
- 12 replies
- 511 views
-
-
I am trying to find out who owns my old car, well the number plate in particular. It is a gun metal grey, LWB, manual, TT, and the number plate is B8 XXL. If anyone owns this or knows who does can you please let me know, it is quite important. Thanks
-
- 7 replies
- 717 views
-
-