Eggs

I purchased this Greddy item to replace the standard plug but am having problems with it continually leaking! Firstly I torqued it to the lower of the FSM settings and the next day was greeted by a puddle of oil on the floor and after tightening further it still seeps. https://www.conceptzperformance.com/Cart/description.php?II=7891 It comes with a steel washer, I'm guessing that's what's causing the problem and should be swapped for a brass one? Anyone had the same problem?

Where is the black box located? Is it on the transmission tunnel?

Sorry thought you said you were going to use a cooler? I've used high pressure fuel line on mine, I can give you the I.D this afternoon when I go to the workshop

I've seen on the Aus site several guys delete that length of metal pipe and run short lengths of rubber hose without a cooler and have no problems

I had the same problem, I used a small screwdriver to lift each side enough to squirt WD40 in and they came out with lots of pulling and wiggling

Sent! Sorry it took a while I couldn't get online properly this morning

I have it but I can't get on photobucket to upload and link it with my current connection as it's blocked. If you want to pm me your email address I can send it to you that way

I'm starting a new job around then but if I'm about I'll pop down and say hi in the daily

Any ideas? I bothered to paint it so it must have been reasonably important?! - - - Updated - - - I have a vague memory if something to do with the gearbox

I'd say no it's a massive amount of work, can be really frustrating at times and to be honest you'd be better off doing some extra re-trims with the time and buying what you want

Nice work! How many hours do you reckon you put into this of actual construction, not including designing it?

I'm pretty sure the R33 GTR discs and calipers go straight on

Love the steering wheel, is it MOMO? Is there an exhaust both sides?

That would be most awesome! I understand the length and ID measurements you need but what OD do you need?

I'm close to putting my OS Giken twin plate back on the motor, does anyone know if I will get away with a universal tool for a twin plate or do I need the OSG specific item?

I'm in Somerset that weekend bud

I'm back in the area mate but no Zed till the summer for me, are you driving yours about, I haven't seen the new one around yet?

I think Nissan will want to sell as many as possible and being a huge uneconomical engine isn't something that appeals to many people anymore, the costs of running a normal car are bad enough

Cheers Si, that would've been handy! £75 didn't sound bad to me either but no harm in asking

03100 Montluçon, looks smack bang in the middle

Can anyone recommend a cheap wheel courier they have used to France? The best I have found is £75 so far Cheerz

By bottom end you guys are saying from the pistons down, correct? If so where did the 500 bhp piston meltdown figure come from?

Glad you're alright mate, shame about the car, it was a cool one

I've got the controller in my 91 JDM, no multiplayer though are they often available?

VK56DE :devil2: Failing that, definitely the VH