General Discussions - 300ZX Related

Had the engine out to do a few jobs, on refitting it I cannot close the gap between the engine bell housing and the autobox. Is there a trick to this or just keep trying. Thanks

Just wanted to know if the little hose that goes from just under the radiator cap (to the expansion tank I think) needs a clip on it or not? Mine hasn't got one on at the mo, just noticed it last night, cos I has to cut a little bit of split pipe off it and push it back on.

Guys need your opinion i recently changed my ecu chip from a jwt to one of john dixons chip everything seems fine apart from boost seems a bit high previously with the jwt chip aftermarket gauge showed 15/16 psi weres know with jd chip same gauge is showing 20 psi which got me slightly worried as injectors,ic's,tubs are stock is there anything to worry about ?? engine seems to run smoothly perfect idle etc

Was it you, gave a wave :dance:

I see you Notts Z boys and gals all the time round Notts - especially the one just down from the Queens med with the Vielside front skirt as it's my commut route but last week was a sad one when I spotted a crashed Z on the back of a flat bed by Nuthall Island. Hope you get it sorted, whoever you are. Cos

Don't know where to begin. Driving along @ 30mph and all of a sudden the car starts smelling of petrol and hesitates and cuts out. After a few tries at restarting it fires up pretty rough with even more stronger smell of petrol. Also the amber engine light on the dash cluster is constantly on now. The rev counter needle is idling between 1.5-2000 revs. The car feels extremely rough. The fan now is constantly on as well. Any help would be greatly appreciated. Thanks folks....

Is it possible to add cruise control to a manual TT? If so how much work and what parts would be involved?

can anyone tell me if the wings west rear bumper meant for the swb will also fit the 2+2 or is there a difference please

Hi Guys Was Thinking Of Changing My Prop For A One Piece, Either Alloy ,or Carbon, Any Ideas Where To Get One From, And Has Anyone Done It, And Was It Worth The Expence Cheers Guys .ian

Hi i am new to this forum ..... I own a 94 300ZX 2+2 TT Auto ..I live in Caribbean... I oredered a Manual 300ZX TT Front Half from Japan so that i can convert mine to manual and have a spare engine and parts What they sent me was a Manual Tommy Kaira 300ZX Front Half...I know from research that its a super rare car ... I am trying to find out if the engine internals are any differnt than a normal 300Z

I know you saw me in my grey Z and seemed quite surprised that there was another Z around! SO which one of you was it!?

Spotted you yesterday (Friday) at about 3pm heading around Warlingham green. Heard the zorst first ;) Steve :)

silver this morning on the wirral, think the last 3 on plate read "lun"

I've been hunting around on the web to try and find a picture that will show me the location of the fuel temp sensor but to no avail. Can anyone tell me where it is? If you have some pics it would be even better. I need to change mine but am not sure about how much work is involved, I'm basing my decision on a lot of other work around this. Cheers guys. Alex.

Got a bit carried away and accidentally sprayed a small amount of waxoil onto the belts. No problems running however when I turn on the heater/aircon, there is a squeeling noise from the belts. Is there an easy way to get this stuff off the belt?

Moreover, can you actually get them? If so and people have fitted them, do you rate them? The steering doesn't become too harsh does it with them? Ta

Just want to see if its the same as mine other one.

This is a long post - be warned! Since my engine rebuild, I must have had a boost leak and not having a TT before, I couldn't tell. I posted up about oil on one of my hard pipes, and was advised that if oil can get out -air can get in and to tighten up the clips. Well I did that and all of a sudden my boost guage has sprung into action and it picks up much better.... I took her out for the first time since fixing the leak, got out onto the M40 and put my foot down as it was empty. Usually I would have got to a cruising speed of between 90 -95 in the time I had my foot down, but to my suprise the car was off the clock (only goes to 110) and the rev coun…

is there a link to insructions on best and easyway to get of please :bow:

Hi all well i might give my new front bumper a go at spraying and fitting never done it before but got to start some time. At the moment it is gray in f/glass need some one to explain what to do put body filler over it rub it down then do again etc, untill smooth as baby bum paint the painting aint a problem its the prep work i`m unsure off any help please.

Saw a blue Zed in Bude on Saturday 22nd July. It was parked up near the Co-Op. Also saw a black one on the Sunday heading towards Holsworthy coming from the Bude Direction.

Hello all, just joined the club, Love my 300zx fairaldy but she is ill. I need help big time, Exactly the same as Ronflat problems. Sorry pal, i am in same situation. Except my car was bought from a dealer only two weeks ago, and been full serviced or so they said, Very clean looking car in Charcoal grey, went to south of france, not zooming as area notorious for the french plod with cameras, that will issue a 900 euro fine on the spot or take the car as deposit. Had travelled about 400 mile's all gauges were good, no funny noises, Then totall power loss,, whenstopped the engine was glowing very hot, but the temp gauge read normal, water pouring out of expansion tank,…

hey is the 300zx z32 none turbo afm all the same as the turbo version

need new Front's for my ZED but what one's to get. i've had Black Diamond on other car (VGOOD) but been told EBC is best on ZED. Also who's the cheepest place to buy from??

finally got my z running yesterday after fitting new lifters etc, but my oil pressure on tickover when warm is around 20 psi (on a aftermarket gauge) is this to low? thanks for any help in advance kev