boldy

Have you weighed the auto box , by fook they,re heavy !!! I know that Darren,s chevy swap ended up a fair bit lighter than the zed set up :shock: :shock:

Welcome to the forum bud , your english is a damn sight better than any of our japanese :bow: :bow: The more over seas members the better , it,s nice to know what,s happening in the car clubs around the globe :dance: :dance:

These are the new turbo water feeds for a plenum bypass , all come off the water pipes at the rear of the engine that feed the matrix . These are the feeds that normally go under the plenum through the throttle bodies and snake their way down to the tubs :nono: The metal pipe on the right side above the turbo is the only original pipe you leave on but this has a small section of rubber tubing connecting it to the turbo , this will need replacing just to be on the safe side . It all can be done with the engine in place , on the N/S you,ll have to take the battery out and remove the hard pipe coming off the turbo to gain access. On the O/S just need to remove the hard pipe off the turbo and be prepared to cut your hands :smash: It,s done with 6mm silicon pipe from Smithy,s HTH

I had the in line one fitted for a while but caused problems as the top rubber water pipe has different diameters at each end, when you cut a section out to fit the inline adapter it,s a snug fit one end but a very loose fit the other meaning you have to try and squeeze the gap shut using a jubilee , but you end up doing them so tight they can cut into the rubber pipe and cause a failure :nono: Lucky for me i was only round the corner from the Z Centre when it failed :dance:

:rofl: :rofl: :rofl: :rofl:

As Bart Simpson says : ..... Your damned if you do and your damned if you don,t ... How fooking true is that :smash: :smash:

Apparently she,s been overheard saying the same :tongue: :tongue: :tongue:

I quit this morning , on the patches now , not feeling too bad so far but god help anyone who cuts me up in the next few weeks :nono: :nono:

Nick at least if your car broke down she,d either fix it or push it to your destination :x: :x:

Dave , that,s the same camera that Daz ( mantav8 ) has just fitted to his tranny van , it,s got great picture quality :dance:

I bought 2 red tail lamps ( these have the correct twin filliament bulb fitting ) and 6 reverse lights but fitted 2 clear lenses instead of the red ones and used coloured bulbs , brake lights were bright but the the side lights were too dim ( being only 5 watt ) so i fitted a ring of red LED,s inside the light to act as tail light . The panel and lights were from the ZCentre :bow: You can see the LED,S here : N/S inner light is a reverse light and O/S is fog again using a red tail lamp bulb but lighting the brake filliament so it,s nice and bright and obviously outer ones are indicators using amber bulbs :dance: HTH

The original pipes they were on were replaced with some of Smithy,s stainless pipes , a mates an engineer and machined some flanges , cut holes in the stainless pipes and welded in the mounting flanges :dance: BLING Here,s a piccy of the original pipes As far as i know dump valves can be mounted on either of the pipes ( one to throttle body or one from the turbo to the intercooler) I,m sure someone will correct me if i,m wrong :dance: HTH

:bow: :bow: :bow: :dance:

Smooth and clear :dance: :dance:

Ive got Blitz ones fitted and the vac pipes have been connected here : It,s the bigger pipe on the left , N/S on the car O/S pipe to balance bar . Hope this helps bud :dance:

Oops , belated best wishes from me as well bud :headvswal :D

I was sat in McDonalds at the time , nearly spat my burger out !!!

FOR :xxx: :xxx: ONLY :x: :x: Spotted this in Edinburgh ?????????????

Nick i.ve got an old pair you could play with :x: Lights i meant :nono: :nono:

Sounds like your prop shaft centre bearing , loosens up after a bit of use hence gets a bit better when being driven or sometimes the rear gearbox mounting rubber can cause a vibration cos it, gone hard with age :x: Hope you get it sorted bud .

Sorry bud , i,ve not got it . :headvswal :headvswal

I was sat in cue of traffic , there,s a lane to my left , empty , out the corner of my eye i see a car pull up at the side of me , strange i thought cos the road for him was clear , i looked over and a middle aged bloke in a Omega smoking a cigar is staring at my car , sees me looking at him nods gives me a thumbs up and drives away !!! Made me feel proud of the old girl :dance: :dance:

Oh dear :headvswal :headvswal :headvswal :x:

Got pi55ed of with mine so i threw it in the bin and bought an all in one HP for £40 from Argos , with the price of cartridges it,s nearly as cheap to do this :dance: :dance:

Some quality work there :bow: :bow: , i know where to come now when i want some phat mods doing :dance: :dance: