zedwizz

warning these plugs will not fit std injectors without some mods to the slot but the rubber boots are the same

im sure ive had some of them in the past Graham

not sure if they sell the rubber boot separate but might be worth asking http://www.thetoolboxshop.com/0-012-71-junior-timer-2-way-connector-2420-p.asp

a rather small rear spoiler maybe?

is it a headless brown cow?

Awesome classy interior best ive seen so far

its a second hand part and from and rad with a broken top hose i changed a few months back so it was heading for the skip anyway. FOC :)

had to double take at that one lol

Right, couldn’t find the new ones (my workshop filing system sucks!) but I managed to dig you out a good second hand replacement. Pm me your address and ill post it for you Monday

This was site was found by another member should be of help to you http://www.z32photoguide.com/index.html or this http://300zx-twinturbo.com/cgi-bin/manual.cgi

near Chelmsford mate

ok mate let me know how you get on. Take some pictures of the install i maybe able to see whats up.

yes the plastic one with the O ring. I brought a load a few years back but let me check first i will let you know

Join the positive and negative of the two LED boards together then join them to the positive and negative of the OEM plug

http://physicsislove.blogspot.com/2011/01/parallel-and-series-circuits.html

I think i have a few spare ones somewhere

Have you conneted the two LED units in parallel?

How have you connected the LED's to the cars wiring? also making sure you have 12v + just turn the ignition without starting the engine and put it in reverse :wink:

Here's the spanners i made up to undo the inner sockets from the shaft of the power cylinder. I made these from 6mm aluminium but if you make them from thinner steel if you want. They are approx 12" long by 65mm wide with a 30mm x 30mm cut out in one end. The idea was that my 30mm spanner was to thick to fit in between the socket and the stops on the power cylinder so instead of grinding down my expensive 30mm snap-on spanner :no: I made two of these job done:thumbup:

ok mate i'll let you know tomorrow

Done this job not to long ago. I made up a thin spanner out of 4mm steel to lock up the shaft on the power cylinder and then loosened of the inner sockets with a regular spanner. I can find out the sizes you need if you want matey.

Pm'd you back marty happy to help out if i can.

my list before and after the Zed. (thought id list the bikes to lol) ss50 RD50 RD125 KE125 CB100n Jawa 350 ZX6r Cortina Mk3 Renault 18 Turbo Capri 1.3 Granada Rover 214 BMW 525i XR4i 300zx TT 1991 (still own) Range Rover LSE 1993 VW split screen camper 1964 (still own) Skyline R33 GTS T (still own) Pajero V6 LWB(still own)

About time Nissan had a decent car in the show room again:lol: Stunning car very nice :thumbup1:

Looks really nice i like it alot. How much did it cost to do? well done:thumbup: