Everything posted by santa
-
Aww..great, really happy it`s gone to terry..now behave! -
I think Gregt may be in need of this
-
Mjp can get springs made to whatever you like. I had standard rate ones made and they`re great
-
its probably the heat shield above the exhaust but under the car in the tunnel..this can sound just like that.
-
yeah sounds a little wuff
-
yeah sounds a little wuff
-
Fuchs 10w 50.. Great stuff!
-
Lower trim in the footwell..long bit of plastic, just use a philips or a pen to pop the centre of the poppers and you should see two 10mm nuts..undo these and now inside the glove box is a screw to undo. it`s on the right, holds a lever to the box to prevent it form dropping too far. Return to the nut area, pull the box mounts off the studs and use common sense with regards wiggling the box free.
-
lol..do your best swedish chef impression..sure they`ll accommodate you then
-
Just so you know, only the top covers have a gasket, for some unknown reason nissan decided that the side covers should use a silicone sealant or similar so bear that in mind when getting the right sort of sealant.
-
Goes on the front whilst you yell EXTERMINATE!
-
like wise..am thinking of new injectors
-
or chavs..little blighters get everywhere!
-
my thoughts exactly
-
a belated happy birthday mate
-
happy birthday!
-
also remember jap and uk glass is different
-
And i charge a fortune lol! As you is all bad boys innit!
-
nope..would like that too. If you do strip them don`t use foam to reseal..take note of all the areas foam is used and use sikalastomer 710 butyl based, very messy but means no water ingress and you can strip again if needed with a hair dryer. last thing ..seal EVERYTHING! screws, holes,gaps. Also good idea to treat the panel with hydrate 80 or similar stops any future rust issues.
-
ho ho ho
-
wonewey..he is so woneley...
-
Might be k seal , that looks like what you`ve described.
-
Bon chance!
-
just sobered up lol. Thanks guys
-
Also, when you do get it open, check the hinge pin, it has a habbit of slipping out slightly and makes things stick. USUALLY THIS! You can just get to the pin with a thin flat blade and pop it back.