General Discussions - 300ZX Related
Z related topics and discussions
79,716 topics in this forum
-
Anyone on here? Never seen it round this area before. Nice lookin zed!
-
- 3 replies
- 327 views
-
-
As above. I can get a pair of them off the net for £74 http://www.conceptzperformance.com/Cart/description.php?II=397&Car_Type=NIS300&UID=20060507140028 Just wondering if they are the same as UK spec? Cheers.
-
- 8 replies
- 488 views
-
-
My Boost gauge is just dead. Had a new engine put in and I think they didnt connect it. I am a new owner so if anyone can help me, Where do I start looking??
-
- 2 replies
- 266 views
-
-
Hey there I have a Auto TT. When ever I accelerate hard the 'power' light illuminates and just stays on until you turn off or change the gearbox setting. Surely the lights is meant to go off by itself after a few secs or mins?? ANy help
-
- 12 replies
- 817 views
-
-
I have a light permanently lit on the dash saying "lights', Can anyone help me this and what it means? (in the Auto Tranny)Also when I accelerate hard a light on the dash that says 'Power' comes on but stays on till I switch off the car. what gives?? Thanks
-
Pegasus close hamble, black one. Anyone on here????
-
- 0 replies
- 268 views
-
-
Something has happened to my valves. The car pulls great then all of a sudden it starts to missfire like a pig and then returns back to normal.Theres no telling where when or why it happens. I did a compression test and no 3 and 5 cylinders are down to 60psi allthough when its running well you would never believe it. I think its time for a new engine :headvswal And this one has only been in a couple of months :cry: :cry: :cry:
-
- 10 replies
- 429 views
-
-
. When my overdrive is turned off and the car is cruising(not accelerating), the car seems to jump up and down a gear like someone is holding it back and then letting go and so forth. Please help??
-
- 4 replies
- 315 views
-
-
Please help guys, New Zed owner and not sure sure where to start looking. Idling very rough and stalls when cold. Also mslighly missing in very low revs but power is there. Any advice will be greatly appreciated.
-
Any help on how to rid the noise from one of the hydraulic lifters? At least thats what I think the noise is??
-
Hi guys. I have checked all the electronics through Nissan but all looks okay. The engine is Idling very rough and misses in the low revs when you accelerate. Any advice or help??
-
- 7 replies
- 455 views
-
-
Do any of the upgrade tubs,i.e. HKS, GREDDY etc, make provision for the turbo coolant pipes? :confused: ;)
-
A few weeks ago the alarm on my car started going off for no reason whatsoever..... A week later the AA came out tested the alternator which was charging at 14.4 said that was ok but the battery was not holding the charge. Went to Nissan asked for a new one as mine is under warranty who told me to bring the car in they would test it overnight.....how could i as the battery was ***ked. Anyway they let me have a new one but one of the parts guys said 14.4 was charging too high although i thought this was fine???? All seemed well then for no reason again alarm starts going off which is now does after about 3/4 hour.....re-set it and it does the same.... …
-
- 3 replies
- 264 views
-
-
Hi guys, Dont know much about engines, but does the 300zx Z32 (1994) have a timing belt or timing chain? Thanks Col
-
- 3 replies
- 426 views
-
-
So, the 300ZX starter motor sounds like it's been running on a Talbot Horizon. Can you fit a newer one from a 350Z that doesn't sound like a prehistoric motor?
-
- 4 replies
- 382 views
-
-
... I reckon. Have now spent ages messing around with new injector & coil pack connectors for cylinders one and six, end result is I now have 5 working cylinders rather than the 4 when I started. However, no matter what I do I can't get number 6 injector to operate, so I reckon it's had it. Bummer - that means plenum off etc etc etc
-
- 2 replies
- 332 views
-
-
i seen a grey zed with a single exit exhaust in weston on saturday lwb an it had a pram handle on it. an i seen a red lwb zed gold split rims an pram handle in clevedon today (sunday) i waved at ya
-
My zed hit 16.6 psi yesterday with the boost controller switched off. Im wagering theres nowt wrong with the BC now and thinking it could be a sticky wastegate. Anyone know a way of bypassing a boost controller to see how it performs stock. Also can a leak in any of the pipes cause overboost like this?? I knew the zed had been trouble free for too long!!!
-
- 13 replies
- 461 views
-
-
Bit of a problem again, I can't seem to engage gears properly, any gear, very rough and clutch bite point is low, no leakage, clutch fluid level is ok, the problem appeared instantly, any ideas?
-
- 2 replies
- 335 views
-
-
import, club sticker in window. Followed us through Limehouse link. First time in ages i've seen one and i wasn't driving :eek: I was in mr2 in front. Karen was drivng and laughing her head off!! :hyper: nick
-
- 2 replies
- 320 views
-
-
if i want to check i`m getting power to a fuse how do i do it and what do i put the fluke setting to. thanks chris
-
- 12 replies
- 502 views
-
-
Does anyone know whether zed o2 sensors are Zirconia or Titania sensors also which colour wire in the plug is the signal wire :confused: :confused: Thanks Allan
-
- 2 replies
- 309 views
-
-
grey n/a with chrome wheels in halfords car park, i was in silver zed.
-
- 0 replies
- 311 views
-
-
Are start motors the same on TT and NA cars? Also are they the same on Jap and UK cars? Need to know as i just bought a starter from an NA for my TT. £20 from ebay (says it works) so bargain either way. Thanks, Ed
-
- 5 replies
- 375 views
-
-
my zed has a knocking noice,but whats miss leading is that it is only over 3000 rpm :confused:. i have had the engines oil changed twice in the past 3 months because i know how important the oil is to the zed's and it is not drove hard. can any of you guys shine a bit of light on the issue i have and point me in the right direction cheers
-
- 6 replies
- 568 views
-