General Discussions - 300ZX Related

have a look. swb n/a. http://cgi.ebay.co.uk/NISSAN-300ZX-FAIR-LADY-1990-TAGA-TOP-BLACK-EX-CONAUTO_W0QQitemZ270122090434QQihZ017QQcategoryZ10402QQrdZ1QQcmdZViewItem

I've just been out for a drive in the Z and noticed my water temp gauge jumping between 85 and 105Deg and the cabin heater was acting intermittently in time with it ie temp 105 - heater not working temp 85 - heater working Where is the water resevoir and is there anything else I should be checking? Thank you

javascript:more_info(200719283453097,100,'CARS',1,'200719283453097',714,630);

I found these turbos on Ebay today! They are Power Enterprise Turbos and are supposed to be good for 760Fwhp :confused: Anyone used these before or have anymore info on these Tubs?? :slap:

Hi Guys Where Can I Get A Gauge To Test For Boost Leaks?

does anyone know if a 350z gear knob will fit the z and are all 350zs 6 speed ?? and check out the watch !!! http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=011&sspagename=STRK%3AMEWA%3AIT&viewitem=&item=320114915684&rd=1,1 http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&ih=008&sspagename=STRK%3AMEWA%3AIT&viewitem=&item=180118149962&rd=1&rd=1

After an extensive search on here, and everywhere I can find on the internet, and FAST, can you identify these for me please? 2371M-41P14 A18-000 MC9K (remanufactured) 23710-47P00 A18-000 ME7 (HP?) They are ECU's I have in front of me, but I have no idea which type of zed they are for. Thanks!

just found this on ebay. listed at 18p right now http://cgi.ebay.co.uk/Nissan-300zx-Twin-Turbo-Red-UK-Spec_W0QQitemZ230132647269QQihZ013QQcategoryZ18238QQssPageNameZWDVWQQrdZ1QQcmdZViewItem knackered gearbox and flat battery but not bad for 18p

I know this post has been done b4 but its my 1st scoobie kill.. It was all over in 1st gear. Twin cam n twin turbz mentalism! Lovely! :nana2: :nana2: :nana2: :nana2: :hyper:

Bought a single piece prop from Z1 and fitted it over the weekend. All looks ok but somethings not right as at 60mph it drones something awful - and it increases with speed. I've checked everything, rotated the diff connection through 180 degrees and even raised the new(ish) rear gearbox mount in case it was sagging - but all to no avail. So, a couple of questions - do I need to ballance the shaft - jubilee clips etc - or am I missing something? Any advice much appreciated. The new one piece prop is steel and the cars a 97NA 2+2. The old prop was unbelieveably notchy especially at the diff end - and the centre bearing looked ok but had a lot of p…

I dont think much to this much to this front bumper. http://images.google.co.uk/imgres?imgurl=http://www.essentialjdm.com/300zx_02.jpg&imgrefurl=http://www.essentialjdm.com/300zx.html&h=396&w=500&sz=103&hl=en&start=117&tbnid=CkfUdjYwc2aYZM:&tbnh=103&tbnw=130&prev=/images%3Fq%3DNissan%2B300zx%26start%3D108%26gbv%3D2%26ndsp%3D18%26svnum%3D10%26hl%3Den%26sa%3DN

Doe anybody know if a clutch master cylinder from a TT fit an NA? Stu

Changing over the stock T/T front bumper for an aftermarket one, as well as doing the timing belt, water pump etc. So as the front end will be in bits anyways, was wondering this. Would leaving off the underneath engine trays help in cooling at all ? Maybe let the air flow around more, or are they better re-installed ? Just a thought ? ;) Alan....

Hi all only boosting 7psi with aftermarket gauge, ran an ecu check got code 13, Engine Coolant Temp. Sensor. I take it its the yellow plug at front of car, see pic, it seems quite loose. I guess i need to replace this ?? please advise cheers :p

Im looking to change mine and am looking for some ideas on how to do it please :) This is what mine looks like at the moment but i dont want to lose the whole boot like I have at the moment and also going to bin the 6x9"s Im losing a lot of bass through the amount of air under the fake floor so will either put them by the inner wheel linings on a frame or just lower the floor and box them under. Any pictures would be great :) Thanks a million

Can any on help, my clutch seams to slid in 3rd, 4th and 5th gear at high rev's but not in the low gears and works fine on hills, any ideas any one??

was just heading into bathgate off the roundabout from the falkirk direction with the roof off was shocked that i spotted another so close to me lol i was the guy staring in the white malcolm mcarhur van lol

can anyone tell me why my turbo gauge says -7 to +7 when all ive read about zeds it says -14 to+14 on the gauge cheers oh its a 91 tt 2+2 lwb import

Any guys got one of these fitted ....non wide arse and what do you think? Dave

Hello i have found a 300zx that i wish to purchase and the only prob is that its a NON turbo :( its a swb manual and i have found a gorgeous VG30DETT engine that i wish to throw into her! Now i have the mechanical skills of a dead fish so i would need somebody to fit the mean machine for me!Just searching around for quotes of prices of anybody willing to fit it for me! Car has 12months MOT so rest of her should be fine just wan2 swap the engine!Previous engine has 78,000miles on the clock so this engine would be up for sale too if anybody wishes to purchase! But nothing is for certain yet as based on Quote prices will determine whether i go ahead with the c…

I thought I'd start a thread off for everyone to show off their new toys, So let's get showing off. Here's mine Defi HUD New coilovers

Just wanted to say a big thank you to Jimmer for going out of his way to meet us at the pub on the way home from Japfest and bring his spare Intercoolers for me...Top bloke, cheers again mate :)

Looks like you have spotted my problem down to a tee... http://www.300zx.co.uk/forums/showthread.php?t=94080&page=2 need your help now because it is now running badly. when exactly happened to the ECU and is it now irreversiblly damaged???

Hi my belts on the front doors have stopped returning they will return if you mess around and keep janking them is there anyway to tighten up the return spring Cheers Chris :nana2:

Ok Boys and Girls I finally over the weekend got the motor button up and back in the car so here are some pics of that whole thing!