boldy

Good arn,t they :bow::bow::nana2::nana2::nana2: Glad your enjoying it bud !

Welcome bud , looks a nice car :thumbup::thumbup::thumbup:

Nottingham county councel are introducing a parking levy to enable you to park at your work place !! it,s their way of raising money to extend the tram lines . Now where i work is on a cul-de-sac and there,s only three buisnesses there so not a major road by any means ,they say we can only park 5 staff cars on our premises after that anybody else has to pay £20 a month !! now most of us park on the road so it,s not really gonna effect us .. we thought , we,ve now heard there going to put a yellow line down the road and you can only park if you buy a permit and guess what they,re £20 a fooking month :taz::taz: Seems like the honest hard working employee just gets screwed over every time , what a complete bunch of :xxx::xxx::xxx:

Sounds like your bottom pins are worn , an easy way of lifting the door back up is to slip a washer between the lower hinge and the door on both bottom bolts . Remove one bolt and loosen the other , find a couple of penny washers that will fit the bolt you,ve removed bearing in mind this has a shoulder on it which self centres it in the hinge itself so the washer needs to have a hole big enough to allow the shoulder through it , lift the door allowing a small gap to open up between the hinge and door ( the other bolt you,ve left in but loosened will keep the door from moving too much ) now slip the washer inbetween hinge and door on the other bolt and re-fit the removed bolt but don,t tighten yet , now take out the other loosened bolt and repeat , now tighten them up . Usually one washer thickness works a treat. It takes less time to actually do than it,s took me to write this ! lol A couple of fuzzy pics , you can just about see the gap where the washers sit inbetween my hinge and door which lifts the door just right. HTH

That looks like sooo much fun :dance::dance::dance:

A model mini :thumbup:

:rofl::rofl::rofl::rofl:

I,d have to agree , i was very impressed with the quality :thumbup1::thumbup1:

Looks tidy bud :clap:, a nice set of crystal front indicators would finish it off though:yes:

I know it,s my sig pic but i really like this one :biggrin:

Ooh i remember that day well :dance::dance:

Got to say Darren,s done a great job of his , looks really good in the flesh :bow::bow:

I,ve always admired that car , it,s a stunning example and that is soooo cheap !!

You wanna see a rotten floor and puny joists , this is what i found when i ripped our bathroom out , it,s in an extension on the side of the house , whoever built it needs sacking !!! You can see the floor dipping . When the bath was filled it dropped about 10mm , not surprising when i saw the so called joists !! And this is what i replaced it with , the bath doesn,t sink now !lol

Hiya bud :thumbup::thumbup:

I,ll be SORNing mine at the end of the week , gonna try and get a bit of use out of it if the weather holds out before then , give it a good wash and tuck it away for a few months till the weather breaks in the new year , by fook i,m gonna miss driving it , the old Volvo ( daily drive ) just doesn,t quite cut it !!:crying::crying::crying:

That looks tidy , nice find :thumbup: Merry xmas to you as well .

I did end up using a blow torch to warm the alloy housing just to help loosening the ball joint to drift it out bud .HTH

My guage pod used to fill up the same , this isn,t a cure but i drilled a tiny hole underneath the top pod , any water will drain out , usually onto your knee but at least it,s not damaging your guages and gives you some time to get it sorted :whistling:

Wotcha Tim , long time no see , you,ll have to get yourself down to a future meet bud :pint::pint::pint:

I bet you can,t guess which one i,d go for :thumbup1: lol

I know alot of folk use the Greddy and the like , i,m using the Gizmo EBC from Conceptua tuning , cannot fault it , easy to use and set up . http://www.ebay.co.uk/itm/Z32-300ZX-Gizzmo-MS-IBC-Electronic-Boost-Controller-/110463793057?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item19b827b7a1 Found a cheaper one ! http://www.ebay.co.uk/itm/Gizzmo-IBC-Electronic-Boost-Controller-Nissan-200SX-300ZX-GTir-Skyline-GTR-T-/370561634046?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item564731cefe

I,m starting to get bored with it already , on MW2 you could climb on things , in things and over things but there,s not a lot of that on the new one , also the maps are very similar to each other , lots of street maps in and around buildings , i have been going back on MW2 just for a few games and all you get on that now is every bugger no scoping with sniper rifles !! you can,t win :taz::taz: or could it,s because i,m crap at them anyway ! lol I,m looking forward to the new Black Ops :yes:

I got it off ebay Chris but can,t remember which seller :oops::innocent:

I,ve fitted the Autobahn one , i think it,s a HKS erm " lookalike " lol. Had no quality issues at all , in fact i was very impressed and it is made to fit the zed properly , i,m even using the air filter set up that comes with it and had no probs at all :thumbup: HTH