hellraiser

Roofs off today drive from Bournemouth to hayling island for a BBQ with my family , it was lush!

Then you should be fine then up to 14 psi, just remember to remove the boost jets upon installation of boost controller

I joined mine to the oem pipe leading off of that one, does the job till I can get mine up in the air

Open ecu to see if the main chip is soldered to the board or is socketed. It's not definitive but if it's socketed it's had a chip replacement, but if your not sure the safest bet is to get another chip

You just need to make sure you have the correct chip (mapped for the raised boost) so you don't lean out under raised boost.

The blitz is just a power supply (ignition on) a ground, and a route through the bulkhead to the solenoid, it's easy, then the vacuum piping is straight foreword too!

Jeff you have been an asset to the z community, I hope you enjoy your well deserved retirement, mark you have some very big and knowledgable shoes to step into, do it right!

I am enjoying my holiday don't you worry ;-)

Just don't become another z tech! That's all im gonna say!

I'm good fella, got myself a tt swb now!

Alright boldy :-)

Well if you have a good rep then it's worth the travel!

Bloody hell that's waay out! Is that the worst you have seen jeff?

Spec?

Might have to disagree on that, my red one is much faster then my old black one Lol

hahaha

Dunno wot u meen bruv, dis is da norm! Chav spk and da gansta shit rally p'd me off fam, ya get me!

I would love to have them but I'm comitted to too much financially at the moment sorry :-(

Joel I have just followed your advice, I know your an aircraft engineer so take your advice as gospel, the z started to run a bit lumpy and started to throw rock cakes out the back! Is this normal or should I just wind the boost up a bit more to 24psi!

Just be careful as they have a flat tang on the end of the cam which gives location on the Cas, if your rough with it it can snap off, causing a bit of a faff when trying to relocate it back on the splined cam

Don't put the cover on ;)

sheesh! dont you know its allAn!

usually naff speedo, you could try resoldering all the joints on the back of it,

Happy birthday bruv :-)

And another for you :-) http://www.aus300zx.com/forum/showthread.php?t=305719&highlight=ptu