General Discussions - 300ZX Related

Parked in the Victoria Gardens area. Spotted from an open-top bus. See, buses do have some uses ;)

Do UK autos need an oil cooler or is it only the JDM cars that need this? Also, how much are they and are they easy to fit?

Just found the picture on google and was meerley wondering :rolleyes:

Went to drive off in the old zed jap auto tt to day, it did'nt seem to want to pull away as quick as it normaly does in first....So i drove it arround the block and returned home. I left it 10 mins or so, and went out to check the fluid levels in the box :smash: , then restarted it. Then i noticed that the little orange power warning light was flashing..It's never done this before :shock: ???? it then stopped flashing and the car then seemed to want to pull away as normal....What doe's this meen....Can anyone help. P.S the power light that was flashing is the one which illuminates when you flick power switch on the auoto box. Cheers for any help Col

Just fitting Jspec fogs to my UK TT. Should the Jspec front fogs also act as side lights? Seems to be 3 wires into into the lamp housing and my current UK connector seems to make them come on in "dim" mode when side lights are switched on. What's the norm peeps? CheerZ Steve :)

got this idea :cool: dont know iff theres any kit out there for the boosted air temp just before it goes into the plenum,must be something that could be plumbed into the hard pipe (digital sensor) and would be really intresting to monitor the charged air temp before it goes in :smash: iff there is such a thing on the market then who does it????????, iff not why :smash: :smash:

Saw last night about 7:00pm did flash me lights and beep me horn but you didn't see :nono: COS You were on YA PHONE :nono:

Hello people, I've been told to contact Mike Feeney in the traders section regarding master cylinder seals but can't find him!! Help please!! Any idea how complicated this is to do as i have a heater matrix to replace too, is it worth doin it all at once, does the dash need to come off for this too? Kind regards Rich Barker

Hi guys saved bout a grand to spend on my z. dont know what on though choice of three!!! 1. wheels and tyres - 18s on at the mo but very badly scuffed must have very deep kirbs in japan lol! 2. body work - although almost immaculate for age, really impressed, would look vewy nice with a shiny new coat of paint though. 3. engine - not really much wrong either maybee could do with a good srevice. slight fuel smell. (recomendations?) :rolleyes: any replys would be nice cheeeeeeeeeeeaz!!!!

As above or do you need T/T calipers on a 1991 N/A to use T/T discs?

Black G reg in Braintree, I'm sure it's someones off here And a new one I haven't seen before, dark blue L reg in Tescos today It's almost like they're getting common now lol I think I started a trend in Braintree all that time ago when I was the only one in my Red Manwell decimating everything... I suppose they figured if they couldn't beat a Zed, they'd buy one instead? :p

Any of you guys got a few clear defined pics of the oil cooler and attaching pipework on a UK spec TT please ? cheers smithy

ok to cut to the chase: a) installed A-pillar pod with gauges (not hooked up to senders yet but backlights work ok :cool: ) b) on two occasions now over the past couple of months when its been raining hard overnight, my alarm has triggered on several occasions for no apparent reason. normally i have no problem with it at all. c) ive got a leaky roof d) the morning after one of these incidents i turned a sharp corner and got a splash of rainwater from below my top gauge in the pod. simple question - is rainwater getting down the inside of the A pillar and finding its way into the wiring and triggering the alarm? the connections are wrapped in electrical t…

might be able topick up some scooby injectors wrx (the yellow ones 475cc i think could be wrong) i belive these are larger than the standard zeds but they look as if they will fit any one know if they will?

Today 5pm ish Black Z M4 Port Talbot...... Dave was it you ?? Cheers Martin

wondered why we dont use them on zeds ?? scoobys use em , 200sx , skyline , pulsars,rx7's ect so why are they not more common on zeds please ?? and i know we have det sensors but knocklinks are far more efficient not to mention newer technology. i had one on my old scooby and helped a shite load sensing pinking and detting.

Going towards the M40 about 5.30. I think it was an 'N' reg TT but it had gone before I could look properly. It's a long time since I saw a Zed in Leamington.

Anyone bought any of these? (bottom of this link: http://www.dta-motorsport.co.uk/index2.htm) Got some from someone else? Is DTA motorsport still alive etc? Just some quick questions :)

The one prescribed for most zeds is PC2-13-4, I don't know if it is cos mine is a convertible with two front speakers but it don't work, anyone had success with any other leads?

Does anyone know of any good, reasonablly priced Shipping companies? Have to ship two cars from Southampton to me out in Canada. I've been quoted good prices for Ro-Ro ships but would rather put my Z in a double container with the other car. Andy

I am trying to find some Indiglo Dials for my Zed... the stock ones are really dim at night and look bland... I cant seem to find any? What price would i expect to pay? Cheers Z Man

I'm thinking of putting in a pillar pod do they make specific one for z or would a universal one do the job?

http://cgi.ebay.co.uk/NISSAN-300ZX-PERFORMANCE-ECU-CHIP-AUTO-Z32_W0QQitemZ8002250123QQcategoryZ32094QQrdZ1QQcmdZViewItem These any good guys? If so they are a good price!!!

Hi, guys & gals - I have recently aquired a 92 SWB TT very low milage. The suspension is all over the place, low and soggy. I need new springs and shocks. Although I may do the occasional sprint/hill cimb, the car will spend most of the time ripping around the Boarders. What do you recomend and how much£££££££

Desperate to get hold of someone that can change my belts and fit a new lightweight U/D pulley waterpump and cambelt tensioner. Mark topless can't do this until x2 weeks Tuesday and Ryan can't until November!!!!! Anyone reccomend anyone else around the London area???? Cheers