rodders25

I cant work this out at all Stupid puzzle game And theres 3 of them!! :headvswal

The rubber plug pulls off then you can get a small bit of wire to bridge the two pins out inside the plug. Dont think it will go with only ignition on, try it though, but also with engine running. Turn on the AUTO and use the ECON button to turn AC on/off. You will see the clutch on the front spinning if its engaged. Give that a go then let me know what happend.

Im using it casue the engine has had a rebuild/bored out etc... and thats whats been used since it has had that done. Its running a lot more power than a standard Z and 10/30 would be way too thin.

Some Millers CFS 10/60 fully sytn cheapish. Demontweeks is £56 delivered. Yikes From Millers direct its the same. Seems a bit expensive to me, anyone know a cheaper place? Thanks

Lmao!!!

Im trrying not to buy stuff, lol, im broke!

Ok, cheers. Will do it that way!!!

I gotta take the sump off. Will that be an issue? Im taking the oil pump off, so obviously I cant sling round the crank.

Bet it cost a fortune!!

Fook that, they weigh loads!

off my head, might have been a 063 or 065.

Im the same, I work overtime, so if im avalible ill be there, if my car works.

I got a 565 cold start amp/ 105amp calcium one from halfords. Smaller than the one that was in there, but had it in my last two and its fine!

Dont bother with 2 stroke for commuting. Gotta top up with oil all the time too. noisy, smelly. As said, if you dont care what you look like, get a Honda CG125. mpg is amazing!!!!!

They go round the opposite way to Kirbz normally. If they go round that way, you will get a little more bite, but also eat pads much faster!! The slots are there to provide edges to skim/bite into the pad.

Turning out to be a right fooking mess!!!

The whole seat comes out, so I would of imagined youd have to modify some aftermarket brackets. You'r only left with 4 bolts.

I want to hold it when I drop the front cross member, but where do I sling it from?

That plants are fake, pretty fooling huh. I did have it fully planted with CO2 feed and ferts etc... plant growth was great, but on a tank that size, trimming etc was a night mare. Like said, it is difficult to grow plants really good. I never managed it perfect. Maintenance is minimal really. Filters once in a while, water change every two weeks. Clean glass etc... Thanks for the comments. If anyone wants to go snorking....lol Oh and I think my cats would rather eat them than me, they spend ages trying to get at them through the glass, lol.

For the dif its silkolene sytran 5, or something like that. not sure on auto box.

Dunno how many people on here keep fish, but I thought I'd post a pic of my tank. Its 2 meters wide and around 650 litres (ish) If I can remember them all, I have: 2 XL angles 3 Bala sharks 3 Denisino barbs 2 gold gouramis 2 indian dwarf gourmis 6 SAE's 12 cardinal tetras 10 black neons 2 plecs 2 ottos 1 rummy nose (the rest died, or got eaten) 2 clown laches Also looking after, 3 tinfoil barbs 1 humbug catfish 1 cory 1 massive clown loach Think thats about it

Not as yet I dont think. Got all my bits on order, so once I fixed mine I shall be able to come to some, YAY :nana2:

Heres some more diagnostics you can run to check all the sensors How to get into dianostics here

Heres a picture

Look through your bumper and you can see your rad. Jsut to the left is a black cylinder about 6 inches long, 2 inch diameter. Theres a black plug on that with two wires to it, one orange, one green. Bridge that out with a small piece of wire and if it runs its low on pressure. But I found my tags in the switch had broke and needed soldering back together.