Paul C

mine cost £7k 4 years ago, prob spent the same in mods & maintenance costs. only times it has let me down was when i first got it - PTU failed, 2 weeks ago - water pump failed

i think mark (topless) at zen garage was doing a deal on complete polybush kit fitting. check him out in the traders section bud :)

i connected some vacuum tube with cable ties to mine to pump it in!!

tell her you have telekinetic powers & bet her £1 you can make her tits move without touching them - have a good rub & give her the pound!! :D

on the age of the cars these days i decided not to take the chance!! it does cost that bit more but is worth it IMO

done mine at the weekend, is really not that hard! took me 1 1/2 hrs on fri night to get it stripped down to the cambelt. took me about 4hr to finish it from there on sat, inc removing all the pullys to do the cam/crank seals all tensioners etc that you get with the 120k kit. prob would have been quicker but i was at work trying to work at the same time LOL! :D

LOL! just stripped it down, whoever done the cam belt last time, looks like the o/s bank is a tooth out (retarded)!!! :wack: will check it properly tomorrow, got to go fit a head on a clio now :rolleyes: :smash:

big box of bits from Courtesy has arrived! 120k belt kit door seals, roof seals & T Top seals plugs filters etc time to get busy! :wack: as iv still got the cluch to do too, looks like JAE's a no go this year :(

loads of us have Eibachs on zeds, my write up: http://300zx.co.uk/forums/showthread.php?t=44300 got mine from the states

no, there is only 9 possible answers based on the 9 times table, 9,18,27 etc. all 9 symbols are the same, tho they change them to another symbol when you play again! ;)

good luck, hope it goes well bud :)

fir T ate - txt spk rlz :D

LOL!! youve been away too long stu - he went in last year!! :D

i use slysoft to decrypt & CloneDVD to burn - never fails :)

the MR2 tubby is a quick car! 0-60 time is not far off a stock zed. after that the zed would pull ahead

is that the intercoolers located behind the radiator?!?!? :x: could have got 1800RWHP if he relocated them to a cooler place!! :rofl:

is it april 1st today??

stick it outside Comets mate!! :D you know you really want to keep it tho ;)

look here!!! : http://300zx.co.uk/forums/showthread.php?t=58843

something like JWT 530's, around $3-3500 IIRC mark (topless) at zen garage would be near you, prob worth giving him a call, think he was doing a good deal on turbo installs :)

spot on!! :rofl:

did it have a new series 2 or a 2nd hand series 1 PTU tho, the old series 1's are very prone to failure if they replaced with a 2nd hand one. there are some tests here: http://www.300zx.co.uk/cgi-bin/manual.cgi?list=efec&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=118&design=default&total=190 they are not always conclusive & sometimes trying a known good PTU is the only answer.

yea, as long as the monkey doesnt mind!!! :x:

could also be the output from the PTU to the coil, usually they fail completely but have been known to fail on 1 cyl

no, 890cc! ;) http://www.junauto.co.jp/products/engine-accessary/injector/index.html?en