Paul Thompson

Are these cheap and easy to replace (yeah right ! :slap: )

I have stock j spec wheels all round with 225's and all suspension is also stock

CheerZ Pete, your a star But :rant: see here http://www.300zx.co.uk/forums/showthread.php?t=64060

OK guys, I have just replaced no1 from Zed Centre, see link :- http://www.zcentre.co.uk/suspension/frontbushes.htm The driver side one was leaking it's silicone. I actually fitted the whole arms with the bushes already fitted but I'm still getting tramlining, steering following lines in the road and the steering wheel sometimes slightly left and sometimes slightly right to go dead straight :rant: So, what would be recommended to be checked/replaced next CheerZ Paul

CheerZ vijay

I'm in desperate need to get hold of him, does anyone have his mobile number please CheerZ Paul

Cheeky I know :mac1: but do you have measurments and a procedure for the sub, that's exactly what I want to do but just 1 sub on the passenger side

CheerZ vijay

Just measured the sender thread and it's approx 10mm vijay

Thanks for that vijay, very helpful, but my sender is 1/8 NPT are you sure it is 1/4 because if it is I will need a 1/8 to 1/4 adaptor. Also, anyone know where to get one from

Sorry mate, will more than likely be heater matrix. I'm sure someone else will be along soon to assist

That will be a Z31 and you have to be subscribed here to sell

didn't think those single seater cars had heaters. LOL

depends how good you are mate anyting up to a couple of hours but more than likely just an hour +/-

Headphone wire has an enamel on it, red and green IIRC, you need to heat it quite a lot to burn it off, be carefull though as the fumes are poisonous, or scrape it off with a stanley knife blade or scalpel

All the best mate, Chilwell is just down the road from me

CheerZ lads, now why didn't I think of looking there :slap:

Is that both front and rear for stock tt ?

Can anyone tell me the size of stock front and rear brake discs please CheerZ Paul

How did you wire up like that hellraiser, Did you change bulb and holder for twin fillament stop/tail light on the inner brake :confused:

What he said, i't cant be used anymore ! so be very very careful or very wise

speedemon, are the metal clips in the dash trim or on the plastic strip do you have a picture at all mate CheerZ Paul

above the stereo and under the vents. Everbody says that these break. I've had a look at mine as it's stuck on with black gobbo but it doesn't look broken. Should it fit into metal clips on the dash as in mine there are just rectangular holes and nothing to hold it in. CheerZ Paul

Thanks for that guys. With the pressure being high, that would put the needle into + wouldn't it mine is actually in - Greg, yes it does go to -20 INhg and to just over +12psi (got boost jets at 1.2mm for now ;) )

Hi all, just fitted the above along with oil pressure and water temp (yet to be wired up). My boost guage needle doesn't sit at 0 when switched off but goes up on boost and down on vacuum. With it not sitting at 0 does that mean I am getting inaccurate readings :confused: Is there any way of adjusting the needle to 0 at all, my guages are made by Motor Sport. CheerZ Paul