jaffa

Travel up to bodymech, I'm in bath and made the trip

good luck and have fun!

Thanks, rear arches are rolled, pulled and flared from a few years ago

you need internal drive nuts ;)

You can have it and you'll need a helmet

I do indeed. If you want I can let the organiser know

Front spacers arrived today, couldn't resist fitting them while listening to a long conference call, dropped the front a little more at the same time with the arch top back in place to give some reference Blue nuts also fitted:) and made a sheet of carbon from some offcuts, this will be cut & used to blank redundant holes

Pete - great work on the bonnet!

I have a track pass going unused if you want to join the rest of the gang

About time! What's each one rated to? (hp or cfm)

Are you sure? Stock height is 48.5 to 49", mine is approx 45" :) were the chassis rails literally touching the floor?!

need it running really to identify the cylinder, then check if plug is wet. From there you can then focus on fuel or spark.

lots of hose few more fitting on order to finish the oil lines ...

Good stuff!

yes, that's a diff output shaft, though not Z32 fitment http://www.300zx.co.uk/forums/showthread.php?176876-2014-work-in-progress&p=1847260&viewfull=1#post1847260

Don't fit my wheels, so ordered some internal drive ones instead and these are up for grabs £20 delivered

Like I said before ;) http://www.300zx.co.uk/forums/showthread.php?180565-Thinking-of-fitting-new-seats&p=1862246#post1862246

I think they bought everything from the SE Nissan catalogue, but it doesn't all work together!

Not much to look at but, mounted the rad, took some measurements for the hoses and fittings I need to plumb the oil side up, cleaned the fluid reservoirs and mounted them, then started fabbing new rear qtr window vents

Just a used set I bought for rolling round on ;)

They're 18x10 et38, but I have adj. lower arms pushing them out further and a 25mm spacer on there. I can see me putting a wider spacer on at a later date but will wait till the car is reassembled and get the geo done first

blue tint is much nicer anyway :)

what are you pressurising it with? foot pump etc sounds like you may have a few more leaks to find

ps you should still be able to pressurise the system with a boost leak detector, what are you using?