General Discussions - 300ZX Related

Whilst investigating the lack of engine undertray, I noticed my car has a K&N induction kit fitted. Spoke to my mate who checked the car out with me when I bought it and he had assumed I knew so didn't bother mentioning it. Saves me £100 or so when I start the mods. Wonder if anything else will turn up when I get a thorough check over from a specialist...?

After my coolant hoses decided to pop a hole I had them all replaced and did a plenum by pass. Just took the car out today after doing all that and had topped up the coolant, but I still have the same over heating problem, or at least the stock temp gauge says so. Soooooooooo, anyone got any ideas on what could be the problem? Bear in mind that I've replaced all the damn coolant hoses at the back of the engine where the leak first started and there is no apparent leakage any where, yet. Time to replace the water pump maybe?

Saw a white one heading towards leicester, Who was it? Looked standard

Saw this between burton joyce and gedling, (opposite the school) turning into a housing estate. i think it was red, it was dark so couldnt really tell

Saw this between burton joyce and gedling, (opposite the school) turning into a housing estate. i think it was red, it was dark so couldnt really tell

I already done my hello thread but this is a hello with a new car :dance: :dance: :dance: :dance: I’ve seen quite a few for sale and wanted to wait for a nice one to come along and one has... DaFox was selling his Zed and even though he is in Bangor north Wales and im in Milton Keynes, something felt right about it. Left my house at 9.30pm on Thursday night and drove up as far as I could without nodding off and stopped over in a hotel. The next morning made my way over to him and all I can say is... one of the nicest most genuine bloke’s ive ever met. He took the day off work and we got there at 11ish and didn’t leave until 5ish!! Great test drive, ran me th…

Hey, I have a HU wiring problem all power is there expect no sound with any of the speakers! The original Bose HU works fine with all speakers This one has been done before - being reading through previous forums Daves diagram on the wiring helps but i have two extra wires Anyone had this before, can help? :headvswal Cheers

http://cgi.ebay.com/ebaymotors/4-GREEN-LED-WHEEL-LIGHTS-NISSAN-300ZX-240SX-NX-PULSAR_W0QQcmdZViewItemQQcategoryZ33713QQihZ001QQitemZ110069478904QQrdZ1 I LIKE THESE TOO LOL :D

Hi i saw you in totton (Hampshire) at around 16:35pm! You waved :)

Ok this has probably been posted before but i have done some searching and not found another thread for it so here goes. I'm buying some new leather seats, they are from a series 2 and the passenger side is electric! :dance: The old manual passenger leather seat will be coming out and changed for the electric one. I have seen a thread before about the required wiring but not fitment. Will I be able to mount the electric seat on the old manual seats subframe or will i need to get the subframe from the car that the new seats came out of? Also help with wiring or a link to the other thread i saw would be appreciated! Merry xmas Ed

Hi All, Wondered if anyone could help with this one.. I bought my Zed a few weeks ago and have not had a chance to drive it before it was delivered from Cornwall. It drive of the ramps and drove to the garage where it was booked in for a MOT (its around 2 miles) no probs. We then get a call from the garage stating the car does not move, so we go down there and true enough it didnt. We left this till the next morning, the car started fine and drove around 300yards before it lost drive, nothing.....The next morning exactly the same. I would appreciated any help with this one as i am new to Zed's :(

On the A56, about 3pm heading towards Skipton. Only realised at the last minute so didn't flash or anything, plus my Gran was in the car and it would have just confused her! And I wasn't in the Zed either so I wouldn't have stood out... Mark

I probably should have pmd the man, but I reckon we could all put in and wish him luck with the rebuild if he did. So then Mr Pone did you get the shell or not and can I or any of us offer any help with the rebuild.

http://cgi.ebay.com/ebaymotors/90-96-300ZX-JDM-LOOK-TAIL-LIGHT-CONVERSION-KIT-FAIRLADY_W0QQcmdZViewItemQQcategoryZ6755QQihZ006QQitemZ160065040372QQrdZ1,been lookin again,think it wood look good?????

:duffer: my fav is the lego men , reminds me of you lot at jae, :duffer:

http://cgi.ebay.co.uk/90-96-Nissan-300ZX-Skyline-R32-Low-Springs-Coilovers_W0QQitemZ140067139536QQihZ004QQcategoryZ40192QQtcZphotoQQrdZ1QQcmdZViewItem,cheap and nasty or a bargin??????????????

hi all, my friends just rebuilt his 300zx but it wont fire, there is no signal going to the coil packs....it will turn over/crank but no spark, also fuel is present any ideas?

Saw a red H reg Z in Bristol on the Bath road...I tooted my horn at you in a green articulated lorry.....was it you???

Hi everyone. Came to start the z today and guess what? it didn't. The engine turns over and fires up for a few seconds and then stops.It must be getting a spark in order to start for a few seconds so could this be a fuel problem? any advice please. all the best for this festive season everyone trev

Because i like wizzy displays ive got an Apexi multichecker of ebay. Now as the apexi manual suggests i will connect the multichecker loom to the ECU loom with those blue halfords cable splitters... so as i can still plug a conzult in can i use both at the same time or is this dangerous?

Come on you guys Steve Kiddells 240Z is the car to beat at the Z Clubs 2007 Drag Challenge Excellent six page article in Banzai Magazine

i'm thinking of turning my standard wheels black does any one know of any pictures of others Zeds with this?? thanks dave

Can anyone tell me if its possible to do the rocker cover gaskets with the engine in the car? If so, how easy/difficult are they to do? Cheers.

Hi ive had my hicas light coming on and off when cold starting which ive been told is normal this time of year ,so i bought some dextron 3 to top it up which i take it goes in the green container to the left of the engine ,but i went to and it looks pretty full so i did t bother, any ideas :headvswal

Bloody Zed I hate it :rant: Well not really I love it :) However it's trying my patience at present. I have no heating it will only blow out freezing cold air its like a meat freezer driving it at present. All the blowers work and it de mists nicely only via cold air only. :headvswal :headvswal