trond

I bought and installed two fuel hoses at 10mm size under the plastic cover on the pressure regulator. Just read that it is supposed to be 8mm size. Do I need to change to 8mm or is it fine with 10mm??

Should be above the oil filter...

Any one know where to get a front bumper reinforcement? (the black one that holds the fog lights housing)

The plan is to fit langer injectors in due time. Also replacing the exhaust with a cat-back and side intercooler from greddy.

I would just like to know if it's just to bolt on and drive or are internal engine mods needed for the JWT 300zx sport 500 turbos?

thank you :) You've been a great help

Are all the suspension and axel parts the same for european, and us model??

still a bit puzzeled. But will it fit a nissan 300zx TT 2+2? 1990 mod

Is the lower control arm the same for all 300?? http://www.courtesyparts.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=54501-Z320289

I've had a bit of bad luck. Car ended of the road and the front does not look good. including steering. So I'm looking to import a car for parts. Does anyone know of a internet site that seels 300zx parts cars??

As posted I have got a problem with water on the driver side. I tried to find out where there water might come from, but it's only the middle of the carpet that is wet. So... Is there any plugs or holse under the carpet??

Well, never know. It could have been an auto before. If so, those anyone know where or if these wires would be? And if it might bee an auto ecu, anyway to check that??

Code 54 Signal circuit from the automatic transmission (A/T) (A/T models only) The A/T communication line is open or shorted Harness and connector. Why do I get this error from datascan when the car is a manual??

Found a fuel leak there. Let's hope it's the one... Thx

Does anyone know if there is a fuel line on the back of the engine?? It drips fuel from the transmission box and I can't find it... :headvswal Even worse when I jack up the front and turn on the engine :shock:

So conzult does the same as datascan + hicas and aircon then?

I've come across two diagnostic software for the zx. The one from DTA motorsport called Conzult diagnostic (315 EUR) and one from Concept Z performance called BlaZt consult ($149.99). Is there anyone that has tried or know something about these softwares and could recomend one..?

check radiator water level

One more thing... I've got a oil pressure gauge from auto gauge.. There are double set of wires for 12v, ground and illumitation. Are all wires supposed to be connected??

Okey... mine idels between 1,5 - 2 bar. At 3000 rpm the pressure is about 5 bar. Is this dangerous high?? running with 10-40 oil. maxed to the top on the oil pin

I've searched the forum but can't seem to find what i'm looking for. Just want to know what the reading should be in BAR when ideling, driving and so on..

hmmm.. would an electrical boost controller remove this problem??

I've just installed an aftermarket boost gauge.. I've got manually boost adjustment in the engine room for each turbo. No matter how much i turn on them i only a boost that's 0.5 bar...??.. Had the boost controller checked at a garage to see if they where installed correct.. They where.. Checked for any error code. Got code 55. So no problem there either.. :headvswal I've got some fuel smell from the engine. got that cause it to run in saftey mode?? And I've also got a collant leak from the hoses in front( going to replace). Can this cause saftey mode without any error code to apear??

Does the samco hoses need to be replaced around 60k as the original ones?? and are they worth the price. (twice the original?

Can a leaking rear crank seal cause low oil pressure??