Medallion Man

titanium keys no longer available though nissan.... you might be able to get a full set from a breaker.. i got one with titanium key after a long wait.... good luck..

I'm more worried about the camber and the wheel not sitting flush on the road.... causing uneven wear....

LOL... asking for my own car... I think it's been done... (not by me) and I need to replace the near side, cheapest way is with a part of a breaker but form a new parts point of view the ajustables are cheaper... (as Car.Mad already said) :) so I'm still trying to find out how low makes the difference....

think you would be better of with a butyl sealant / tape, stay supple and is a better seal... yeah, a bit messy but does a better job than silicone.... it's what the lights are held in with....

OK, so you can use the ajustable camber arms anyway but at what point (i.e. amount you've lowered the car) should you use them?

pics on ebay....

Ouch!! that "dirty old thing" is mine and I posted it to someone because I need a new one.... and as it's been poited out they are not STD. poo, what to do...

if you insist on going ahead, be very careful it don't end up a mess..... really don't think these cars need it....

sorry to thread jack... Hi lymon, any change of some info re: mappings for my cars spec? I'd rather give you a run down & specs via email. cheers.

yeah, same from me... all the more reason to go to the meet.... :)

not possible on the Z as the section that is left over is protected... you need to either use easy-out drill bits or drill a couple of holes and use some pliers..

here.... for the doors.. http://www.pexcom.com.au/z32cms/e107_plugins/content/content.php?content.504

I'm sure I've seen some stuff on changing dorr locks.. could be on the Oz site.... you'll need some shear bolts from Nissan for the ignition (about £5)... getting hte ignition off is a bit of a pain. good luck.

hi, i assume you had a new chip put in as well as the injectors.... (i think that is how it works :) obviously, depending on the size of the injectors)

LOL... I bet I'd also be surprised just how many people actually gave their details...

waved at me from a blue Z... :) My first spot in Wales..lol..

the little T&&T got what he deserved!! lol...

If Dan can't sort you out, i got my last set (front and back) from a company on ebay called conceptua-tuning.... You'd have to email or ring them...

another thing to remember is that the width of the wheel is taken from inside the lip, not form the outside edge, so if you are measining from the outside of the rim it's best to do it from both sides to find the center of the wheel.... then you can measure the offset..... off set of "0" is only good if that (or close) is what fits your car...

so then both your offserts are "0", but the add says 5.... (not that 5 mm is much anyway) did you look at any ways to measure it? http://en.wikipedia.org/wiki/Offset_%28wheel%29 and this is helpful..... http://www.1010tires.com/wheeloffsetcalculator.asp

http://www.300zx.co.uk/forums/showthread.php?t=133770&referrerid=16305

should be....... www.autoadvan.co.uk/

have a good one....

Me too... :)

Ah, thought as much....these adds are always on the wrong side of honest.. LOL... guess I'll stay with the hose (particullay at £20 for the stuff)