Steams

Welcome matey :) hope you get your problem sorted.

what's the costume look like mate??? :D

Have a look here mate http://nissan4u.com/parts/

Have you been reading wikipedia?? :x:

T-Cut won't get ride of stonechips mate, you could try some G3 but if they're deep you will probably have to try the touch-up pens.

Don't think you can remove the loom from the relay boxes, my one was hard wired underneath. Don't know about removing them, however the fuses do come out by the method you mentioned.

Welcome to the wonderful world of zed ownership, ohh and the club! :)

Think you would unbalance the braking if you had the oem 4 pot calipers both front and rear.

Contact cleaner and a little file.

Am I right in thinking that to totally eliminate the fluid side of the HICAS, I just need to replace the PAS pot with an NA one, or is there a bit more to it?

Just push down with the flat blade as you're doing, you should hear a little click then just pull. The connectors have probably oxidized and stuck together.

Looking really nice mate :) loved the 31.

apart from getting the auto box off mine, pulling the cables apart was the main PITA for me! Sounds like you've made a good start :)

Mark the prop shaft at the join next to the centre bearing, undo the bolts on prop, remove the centre bearing mounting bolts and the prop should slide out of the gearbox. Probably better to undo the electrical connectors before you jack it up, unless you're really tall and can still reach round the back of the engine. Good luck with it mate :)

Welcome matey :)

If you've got a compressor you can blast air down the holes to clear blockages. You could also try some Captain Jack's creeping cure (think that's what it's called!) that may help re-seal the trim.

The tw@t got nicked for it! now that's funny.

I had them on my Vectra GSi and tbh they were crap. The car was wheel hopping every time I hit the loud pedal. Definitely wouldn't use them on a zed.

or ask MJP for the nissan touch up cans, they may still do them. I know they still do KH3 black.

Welcome matey :)

Mike at MJP told me that the JDM TT discs had a different offset to UK TT's :confused:

I'm doing my own, replacing the seals on the calliper pistons cleaning them up I've also bought stillen discs (same size as stock TT)and pads and the SS brake lines. This will make the brakes better than stock but it isn't going to compete with bigger callipers and discs.

:dance::dance::bow:

Probably original stock :wack:

God I hope it's good :hyper: Atlantis was cancelled after the fifth series.