The rebuild has finally started today and so far in a few hours I've managed to completely strip the interior.

 

 

 

Next job on my list is to get both the bumpers, tailgate and bonnet off.

 

After that i'll work on the body panels and stripping down the engine.

I was about to fit the clutch but managed to lose my pressure plate alignment tool.

Life just likes to kick you down like this :(

Found the clutch spline, but anyone spot the mistake ?

What did i forget to fit before the flywheel ?

34 minutes ago, JaiKai said:

Onto the clutch and this was fun fitting and trying to torque up without it rotating.

Eventually put a large socket in the front pulley and let it push against the bulk head.

The spigot bearing

Edited 27 minutes ago27 min by Bones28