Joely P

Need to set the final height as its a bit low. Here's a little peek, excuse its filthiness, it's covered in quite a few months of dust!

Surely not, fully efficient?

JML gaitor grip!!

My name is Bob Watson so mines pretty obvious..

By all means you could try, I guess, like johnyboy has experienced, it all depends on the opinion of the rozzer on the day or the judge if it goes further and you kick up a stink! I think a bike size plate is asking for trouble as they're tiny. Have you considered using a 3/4 size plate like I use for show use? No issues in 6 years although its not a daily drive.

What are the best options for this chaps? Selin jobbie?

(1) does not have European Community Whole Vehicle Type Approval and (2) is so constructed that the area available for the fixing of the registration plate precludes the display on the plate of a registration mark in conformity with the requirements of regulation 14 (see the 2001 document). I'm not sure about point (1) but, ref point (2), as there are no restrictions on the front bumper for a UK plate we can't use that old chestnut.

I wonder if he pops on every now n again, happy birthday matey, hope life is treating you kind and you're no longer driving a modern sporty MG :lol:

Put your seatbelt on! :-p This is me for the day, accompanied by a visit from the chap at arch enemy...

567fwhp @ 22psi

CheerZ guys :-)

Have you changed to led bulbs?

Certainly familiar to me but I bet this rings true for a lot of members on here :rofl:

Good plan! Following that I think I'll need a little phone call to arch enemy...

Happy birthday bud :-)

I had exactly the same issue as you Brian, fresh engine build with same tubbies, run it in, up the boost and... Pop! The exchange rate was v good at the time so I went for the Z1 GT525's, not ovally laggy but a fair improvement over stock. The difference on launch isn't massive but the GT525's don't run out of puff towards the top of the rev band like stock so pull a lot stronger through each gear. Worth a butchers...

I have 4 19" Volk TE that need to wrap themselves in the 4 eagle f1's in the garage, any advice?!

Thanks fellas :blush:

Thanks fellas :blush:

As fitted to the SMZ models :-)

As fitted to the SMZ models :-)

Can't go wrong with a fluke :-) Unless it goes wrong, in which case, you've possibly gone wrong?

Can't go wrong with a fluke :-) Unless it goes wrong, in which case, you've possibly gone wrong?

Happy birthday matey :-)

Happy birthday matey :-)