MarkDerby

the box is a straight thou as well as a baffled ... there is a diverter valve that redirects the gas in the baffled part of the box back out the tail part

not new m8 ...

Neil i have one of those .. can u send me a pic just to make sure its the same

EBay ... 45quid 4 wheel

yep lukes car ... me and ceejay will be there tomorrow as well

Gave the car a Polish Ready for Car Fest tomorrow

happy birthday m8 :)

Any vac leak can make the idle erratic

front left/passenger side ... there are quit a few vac lines ... Main one is Turbo Actuator line feed .. tucked under the Large inner boost pipe then there is 3 smaller ones between the large boost pipes 2 are for the carbon canister 1 is for the Recirc valve or dump valve

lol @ jeff

so are you wanting to do a NA >TT conversion on your car ? or was you just thinking of using a TT engine instead of NA .. as if u was thats a no go really think the best thing to do Mark is Ring me tomorrow at the workshop and we can talk about the Problems u have and about the NA>TT swap Mark Zedworld - - - Updated - - - lol .. jeff got there just before :)

The thing is I did post a link to it months ago ... And on the Fb side too ...

good app had this on my phone now for some months

Happy birthday m8

i would assume it would have to work with in the abs sensors and your handbrake .. sense car as stopped hand brake applied engine stop then to activate it to start would have to be on throttle press to switch engine on ... and drive away but realistically the stop/start of any car is only a small saving of about few mpg over a tank full is it really worth it ?

all cars have it anyways ... its called using your key :)

that pipe is for the aircon ... Main pump pipe it has an outer rubber plastic protector on it .. with the age of the car chance is it will be slightly worn and cracked ... but its only the protector covering

Yeah loads left and its massive ... lol

Here ya go

Thanks girls for your birthday wishs Been a full one today even with cake of a red car :) Mark

Ok been thinking a little more on this the Trip will take me there abouts 16hrs There and the same back Going by Ferry to keep the cost down ... Euro Tunnel is way to much for a Van ..

Smaller one of the Lot .. 4mm Pipe .. Others are 6mm and 8mm in that place

use the 4mm take off on the balance bar on the drivers side

undo the Top Bolt where the peddle is and the two nuts on the Master cylinder in the engine bay ..

if your drifting ... you will not have any wheel arch liners anyways :) no regardless of what wheels u have fitted they be no rubbing