gruntpa64

Here it is, its a right bar-steward to get to

Small plastic yellow bit is broken on the tumbler to the locking bar or has jumped off I would think Allan

You need a door lock motor to be fitted on your drivers door to get an alarm to operate the central locking. There was no fob locking when the early cars were built I dont even know if remote locking was avalible on 95 on? Allan

Here you go

Quite happy with my single exit!

Bodywork Plus Cradley Heath http://www.bodyworkplus.co.uk

Steve at Bodywork Plus, cant fault his work at all, and I am sure that the folks that have seen my paintwork will vouch for it. It wont be cheep though I know you cant tell from a picture too well and the car had just done 60 miles on the motorway

Drakkar Noir, by Guy Laroche and Lacoste

Get yourself a bank loan for an extra 3.5k and you could have mine, welcome aboard

Bingo callers dream today All the fours!!! Thanks Guys

Hopefuly this is on sunday 21st december?

You would be best going to Frombridge Mill just off the M5 as there will be verry little parking at Dursley.

I might be there as i get the Z back on Saturday.

Thats because you have no production or tallent:rofl:

Dose it matter who sings a song, is it not the song and the production that counts??

You need to get it on a conzolt and look at the operation of the o2 sensors. Look in the conzolt nere you thread to find out who has one near you. Also check for vac leaks and clean the ecu temp sender and conections, see engine by numbers to locate it. Allan

Just checked jimmys clamps and they are Tbolt clamps. Cbolt clamps have a clasp that opens up to allow you to put the clamp over the pipe. Tbolt clamps you have to slide the pipe through the appeture. TBolt clamp CBolt Clamp Allan

Hi Smithy The problem i have is the boost slipping the jubilee clip on one of your hardpipes, then it gives me a stall untill i can get it tightend back up again. What sizes do we need for your hard pipe silicones. (my car is in birminghanm so i cant measure them at the moment) Jimmy hows the concept ones fit ok? Thanks Allan

Jubilee super clip range 48-51mm 60-63mm Mikalor Supra w4 clip 47-51mm 59-63mm

Further to the thread regarding the above, and the fact that normal hose clips are not man enough for hard pipe silicon fitments. Here is a link for a company that will do stainless steel (316 the best) tee bolt clamps in various sizes. Hope this helps those who need them (myself included) Allan http://www.stagonset.co.uk/fasteners?t=1229026987&page=stagonset_index.html&cart_id=2041774_21015

FFS unblivebulll ;)

Here you go + =

No Magnet in the sump plug, thats in the autobox plug. if there is bits in your oil you have not changed the oil regularly enough, and the filter is not working.

John you have pm

same here!!