greg

idealy yes,much safer if you do,not only will the chip more than often remove the limiter and up the rev limiter it will also or with some chips make the car run that little bit safer,so yes id get the ecu socketed

:rofl: i do take a bit longer im a smoker of 20 an day so jacking the car up and im knackered!

:bow: LMAO

its common for the starter bolts to loosen over time and starter doesnt sit flush to bellhousing causing it to make that horrid noise,may be the starter but dont condemn it until you have checked that if left for to long it may well damage the flywheel ringgear which is gearbox out obviously :(

jack up car support on axle stands remove live lead on battery,otherwise YOU will get a shock LOL discconect plug from starter motor grey one IIRC whic if still there will be supported by a bracket remove 10mm remove lower bolt 14 mm theres also a nut above that at the top of the starter,remove that! use a ratchet with short extension and a uj to make life easier,last thing you want to do is round it off! now its ready to pull out from ringgear its much easier with exhaust off,but if you wiggle and manipulate it,it will come away from bellhousing,you can remove the heatshield on ther starter but you shouldnt need to 3x10mm bolts let starter motor hand down,then remove main power lead from battery which is attached at the back 1x12mm nut job done starter motor removed HTH greg sounds long winded but 10-15 job,not the exagerated 2mins :)

your be ok mate just take your time,and as said use a good engineer to do all the matching etc :cool:

i am certainly not a racist,and in most cases its the minority that spoil the general muslim comunity :mad: take for instance if the whole country did a poll wether we should or should not go to war i bet most would be against war,but as per ****ing usual theres no freedom of choice,are lives are put at threat due to a selfish govenment :mad: it does boil my piss though as this small minority ruins it :( oh well look after your own is what i say

well done mick top banana :bow:

to replace the det sensor its plenum off fuel rail etc but you could get a resistor and bridge it across the det sensor plug cost about 50p if that,only downside is you wont hear any dett do a seach on how to then safety boost will be removed

very nice

pleased for you mate,nice when it all turns out good :cool:

yeh nice car,although when it was at ztech it needed the bodykit tidying up as the arches were a bit chipped etc,but nice looking car all the same,enjoy it mate :cool:

they look like the gtr skyline rims,i think mr shrimp had some similar IIRC not to bad alan

LMAO wht do you expect with guests named t-pot you sound surprised :D only joking mart :cool: ;) nice when everyone meets up,and can go for a cruise

just thought yours is an auto even easier :x: forget the booster and and master cylinder part above :wack:

i had that fitted to mine in the cars early days,the stick stuff was crap so i superglued it on,took me an hour to fit it,as i knew one mistake and it was game over,the bodyshop loved me when they had to take it off to re-spray car LOL

dont take the dash out to late :wack: slackn master cylinder remove clutch pedal from booster remove heater amp remove 10mm bolt from bulkhead remove in and return pipes from matrix and couple of screws and slide out :wack:if you need any advice send us a PM BUD

bugger,good luck loosing the weight mate :)

common problem when from cold on first startup is valve stems,but could also be the breather systym or as said worn seals on the tubbies,when your up mate,we can look it over :)

si if the car runs fine then a compression test should be within spec,it may be down slightly on compression,but unless you had new rings then thats how it is however you have only replaced 1 pcv then you have to remember there is 1 more pcv and 3hoses have the lot replaced,even the ones that go to the hardpipe-intercooler,as your getting the main seal sorted,then im sure the turbo oil feeds and return will be checked for possible leaks as with the rear cam seals and covers etc if it smells of oil and there is no smoke from zorsts other than condensation,then id put my money on just a general leak which will hopefully be sorted,when its being checked over

7 teen thought id put the 7 infront,makes it sound better :smash:

karlos may aswell own a 3 wheeler when you show him up down the strip PMSL :dance:

wheres cilla black just for lil pinky cilla black use to present a program over here getting couples and blind dates together :wack: iv got pics and vids of me on http://www.bluemovies.co.uk just look up pimp magic and you can see all :smash: :cool: :tongue:

differant readings in cyprus :tongue: only joking

just **** it up :D top secret get 4 space saver wheels paint car matt white and fit them,it will look the *****x :dance: but seriously sort the engine if thats a success then go mad with the spraygun :cool: