j1mmytt

wohoo im winning :D did they get some money back from the previous garage?

pivot ball missing? clutch booster pivot ball rod missing? slave cylinder rod missing? release bearing clip missing? i give up.

My gran fitted it?

only replaced friction plate?

pressure plate incorrectly tightened?

erm friction plate wrong way round. lol

bloody el your quick.

water drainage holes blocked?

transmission reverse spring, stops it going in reverse when your driving over a certain speed ;) when it brakes it wont go in reverse and has to be replaced.

lol nice.

Yeah the steering bushes make a big difference to the feel of the steering, more responsive and will eliminate alot of the loose feeling.

yes please :D

Have you even looked at the driftworks hicas kit? its better than that stillen bar rob ;)

I heated a knife and kept melting away at the sides until it went in tight there was no need to secure it as it was a very snug fit.

Yep i alreayd cleaned that up and gave it a nice coat :D wasnt bad anyway.

Ive got a tub of underseal that i use underneath on spots of rust patches i see, so far there is not much at all if any but i like to keep it that way, i just wire drill till its clean and brush it on do you think that will work?

youve plastered it in under sealant hmmm nice, bet theres loads of dust stuck to it now lol Will it still not rust under the sealant?

so its the side wall x2 which is 45% of 255. is that correct, tyres hasve always confused me. so do offset messurments

snowygt's gunna be jelous.

my god... 99 spec parked on a beach?

:dance::dance: isnt it more like 69/31?

visit their site. Ring them and they will advise you the best option. Im pretty sure they will fit though.

If they are the right length and have the correct amount of adjustment yes.

ARB=anti roll bar. they wont be as stiff as coilovers. More comfortable ride. yeah front and rear camber arms u will need.

could be a number of things, like when your braking more wieght is transfered to the front and anything that is loose of worn will flex causing unwanted steering under braking, but brakes are normally the cause, but yours are new. is your tension rods caster and tracking set up striaght? looks like ya got some investigating to do. by the way the rear calipers could also cause brake steer if one is out slightly or siezed etc