b19rks

The words Amway and Kleenezi spring to mind!!! ;)

i bet your boot isnt closing properly, if you remove the centre panel inside the boot, youll see 3 bolts holding the latch on, my bet is these have come loose or the latch has got knocked down a bit, try undoing the nuts asnd sliding the latch up or down see if that cures it.

WTF are you lot on about? The fronts are both 21 inch and the rear is a 21 too as standard but you can put a 23 on it if you wish. IMO Bosch are by far the best blades, i tried Valeo silencio ones but they only last a few months. Bosch part nos are SP21S divers side SP21 passenger of SP21S if you want a spoiler on that one too, and you can put SP21, SP22 or SP23 on the rear. If you buy these in halfords or the like you'll be looking at over a tenner a blade. I love my job sometimes!!!

I could be mistaken for the big asian dude, except for the fact im not asian....... or big .........and my zeds not silver...........and i wasnt in Leicester either. I might be the other one buts its doubtful as mines not white with big wheels. Are you sure you dont mean a super fast red one in nuneaton??

Check its not the pipes thet go into the bulkhead for the heater matrix, these are dead qick to fit about half an hour and are available from mjp for about £35. If its one of them crappy little plenum hoses i'd just do the complete bypass cos the moment you replace one another will go.

Mine could of failed on one duff O2 sensor but my good old mot blokey simply tested it on the other pipe instead!!!!

you were warned, it will also fall off if you play with it too much. :rofl:

Your right, i'm going up in the world now!!! :rofl:

sounds like someones put j spec bulbs in, if so theyre H3C bulbs, but beware they are poo as theyre 35 watt and cost upwards of a tenner each.

At least we agree on one thing :cool: Now, if you just admit that I am a bigmouth shitstain then thats fine!

Who are you then??? Tuesday or Weds morning about 8.30am A444 bermuda park. :ttiwwop:

Its Japanese, lol

Not room for 2 fat men in the darkside???!!!! :rofl: :rofl: :rofl:

could be a sticky shift lock gizmo, check the little plastic thingy on the front of the gear lever has not come loose and tat its movement is not restricted. I had this trouble when i first put my razo on before i worked out what the fook was going on.

I've got to get myself some new ones, so im going to have a word with a few contacts from work, i know i can get the 225 50 16's at £82 a corner inc vat, not sure how much i could get off that if i were to buy a load though.

Normally do about 400kms to a tank, which is about 252 miles, have had about 350+ miles on a long brighton meet run, but also had not far over 200kms when doing all short winter runs.

Mine does that first time i brake after leaving it in the garage for a while, i'l have to check the fluff out then!!!! One more for the "To do" list!!!!

Gay.

put mine down as 3 to 4 years, as im just about to come upto 3 years zed ownership, And there doesnt seem to be a 2 to 3 years box!!

yas, cant you find a "witness" someone must have seen something!!!!! ;)

Looks like somepikey turned up in a land cruiser, he didnt try to sell you a dog did he???????

You can if you wish, i think ADL Blueprint do one, not sure if the major manufacturers do them though, i'll have a look at work tommorow. Having said that Nissan will only sting you a tenner for one anyway, dare say mike will charge a damn site less than them too.

could be eitheirthe tubby pipes,or one of the ones off the plenum. The leaks can be very deceptive as alot of the time it will un down the pipe and dripp from somewhere completly different from where the leak is. I should know ive spent hours and close on a grand trying to sort all my leaks and after a new rad, plenum water bypass and every remaining hose being replaced my problems are finally sorted. Problem is that the cooling system carries quite a pressre and leaks will tend to always start from the weakest link, and if youve got the factory coolant hoses still on the car quite a few of them will be very soft and sponge like. Thus when you replace one, the next one will go. This is what i had, i did the rad and the tubby hoses started to leak, got that done and the plenum pipes started leaking, got that done and the matrix ones went. Good luck mate, sorry if ive scared you with my tale of woe!!!!

Is it just me that thinks it looks shit gay and slow then????? Oh no its not, Chunk agrees with me too!!!!

you are right, lets just hope its in as good as a condition as when tony owned it, as those pics are from a while ago.