jayjay93

Hiya guys really need a prop shaft for my manual conversion thanks

Awesome ill be camping over the weekend after changing my timing belt tomorrow

hiya guys, about to go pick up an manual conversion but need a flywheel and fairly quickly so if there's anyone in or around London id be willing to come get it :D thanks

well I'm determined to go as it is going to be my first opportunity to drag race :P very excited! As long as the weather holds out it should be an awesome weekend :D

So then guys who's heading down to pod this weekend? just spent the last two days getting my 300 ready, and finishing him off today :D gunna be taking laptop with datascan for anyone who may need it (including myself) ;)

Need the strip for the boot lid. Mine is missing :( Thanks

so my insurance starts starts in a week and want to get some bits sorted. need this pipe going from the receiver dryer to the condenser, also need the condenser as mine is cracked also looking for rear perspex strip and the scuttle trim above the battery thanks in advance :)

Anyone got 10 or so standard wheel nut knocking about? And a rear wheel stud as one if mine has snapped :( Thanks

i know there are some good deals on ebay but personally id buy something known and trusted like the one on zcenter, and im not 100% sure but think these interfere with the 112mph speed limiter, so it wont be limited anymore ;) iv left the 180khp set in mine as thats what the little box is creating a signal for. putting mph in would make it read wrong. not to mention they only got to 120 ;)

Hopefully I'll be there if I pass my test next week lol

haha yeah its not really a economical car as it is :P but mine will be a daily driver so anything to help.

are there and cons to the na diff? such as fuel economy?

i also have conzult, only the free version though

well guys today while fettling wires under my dash i noticed that the steering column isn't attached to the plate that's bolted to the firewall so i can see light from outside in the engine bay, this strikes me as odd as i have no idea how it could've happened as the top is mounted correctly... only thing i have thought up is maybe it was replaced at one time with a swb one?? not sure if they are different though thanks

99 spec any day ;)

i believe there should be a separate switch for the rear fog light.... so not coming from the front fog lights.

have them sitting around and are fairly tidy just not quite my taste, make me an offer. will also steam clean them :)

So there's a spot when its warming up that i runs like crap?..... highly doubt its got anything to do with fmic, that would only change inlet air temp. unless there is a vac leak and im sure that wouldn't cause this issue. Next time it dose is try pulling plugs of your coil packs one at a time, if you find one that makes no difference there could be a fault with a coil pack/injector or maybe the injector plug. i had intermittent issues due to plugs. hope that helps :)

Hahaha I wish mine was that low guys XD gunna cost me 2700 due to my age :(

Wasn't too bad, just cut the brackets off all the seats. Then bolted the old zed ones to the RX seats using box section

Got to say, when I brought my zed the guy said it had a replacement compressor fitted. But the clutch was knackered, think it was because it was fitted without any oil in the system which blew the compressor up. So think mine is now on its third :/

Its possible but surly its cheaper to replace it?

stuck some RX-8 seats in today :D heated and everything :P

in need of a new speedo. not too fussed on uk or jap as long as its a turbo one :) thanks

i removed the AIV's yesterday and all is good :D and i replaced a load of vac lines too seems to boost better now, that might be my imagination not sure :laugh: but anyway thanks for the help and i will be doing the egr when i pull the engine to fit my recon turbos :D