mantav8

Go to Traders section and check out AndyZ and Dave at PetrolHeads, they will sort you mate! :)

Been looking for a pair of nice after market mirrors for a while now and finally found some.sure someone was asking about some on here?? Anyways when I get em i'll put pics and details up as words don't do these justice!! :bow: -Quality is excellent and they are electric-can't wait :dance:

-Can you get bored again bud :D -thems the b**locks!! I'm up for a set of four if you can do the rears aswell? let me know mate.[apologies for nicking your tread Dave,but great minds.....]

I must get around to using the woolies kit to clean up the front seats. Yep me too bud,-hey if you like the look-fek em all! :D

Bugger....the wifes got a murder on and won't switch over! :slap:

oooo,that's spooky,just been looking at these on ebay,but they look like the cut to shape plastic jobbies :rolleyes: If you can sort these mate you would have another taker!! :)

Have not had a call as yet,but have had three e-mails in a fortnight,all alleging they need confirmation on accounts! :xxx: One was 'verified by visa' the second 'Sun Bank' and the third 'TCF Bank' or some B@llocks like that. So in short watch the mail also,anything dodgy fook it off!! :)

:dance: :dance: ;)

Good luck bud,-you will feel a lot better this time tomorrow!! ;)

:D -BTW-Nice sig! :bow:

Cheers Andy,and of course JD!-sounded too easy so I thought I had better ask the experts!! :bow:

Been on the Greddy site for instructions on the ProfecB and what I can make out is that if you tee both actuator pipes together and run the tail of this to "com" on the solenoid that should be o.k. Then take a pipe from the boost side of things[ie balance bar]and run this to the control box. Now the querie,can I simply take the electrical connectors off the original solenoidsand if so do I have to remove/replace any pipes connected to them or simply plug them up? Cheers! ;)

Cheers,a good read but the pics don't load! :rolleyes:

Oi! I have no problem keeping up!!!! :tongue:

Give it time Vinz!............ :D

OH! :nelson: :o

Try here mate! ;) http://www.aus300zxclub.com/tech/heater/heatercore.htm

Yup-you made me lol a few times-good hunting bud! ;)

I had this at the time I got on the Forums....So just stuck with it! :D

Hey, Boldy-you doing anything tomorrow, Iv'e already got the hinges........... :x:

"Very rare" :D

"No test pilots" :xxx:

:rofl: :rofl: Saw this on mr2oc, had to share!!!....WTF :slap: http://img.photobucket.com/albums/v77/chosen_one2003/pic3.jpg

Try checking/cleaning the ECU temp sender connector, if that don't cure it do a search on here HTH :)

Just ordered above from Chris and wondered if anyone on here has any advice/tips,before I try to decipher the instructions!! ;)