Steams

Nice one :rockon:

I was wrong, it starts at 2am.. doesn't finish till 6.30 tho' so the fight will probably start at 5 :cursing:

As above, It's on sky sports at 1am but I don't want to have to sit through 4 hours of second rate boxing before hand, been caught out like that a few times.

Beat me too it!! I was going to offer my services :clap:

Don't know where to start and then wouldn't be able to stop so everyone and everything should cover it....

Welcome matey :)

Nice one mate. I've got a couple of induction cones for them but in the end I went for a pipercross panel filter as you don't notice any difference in performance over a standard filter. Some people have made up steel shields between the engine and filter which helps deflect heat away from the cone. Something to be aware of is that K+N type (oiled) filters have been known to clog up the AFM.

I'm replacing the "rubber pipe" bits from the main lines to the caliper, so I can't cut them off. I've got a crow's foot that should fit over the pipe, I'll give it a go tomorrow.

I was using a standard open ended one. Thanks for that I'll get the right tool and hopefully that will do it. Cheers Dave

Stick an add in the wanted section mate, somebody is bound to have one.

I'm going to change the front brake lines for SS HEL ones, problem is I can't get the connector on the inner wing to undo. I've plus gassed and wd40'd it but the connector is just rounding off on the spanner. Does anyone have any tips on getting these undone?

Sorry to hear this mate, you must be really pi**ed off! I always put a couple of big blokes front and back of the wheels when I jack it up.

You got it then mate, looks nice. How's it driving?

If you have a look in the online manual, it tells you everything you need to know. The service bits get added to as the car gets older.

Check the lower ball joints and tension rods for goo oozing out. If the wheels were put on with an air wrench you're discs may have been warped.

I'm glad that common sense prevailed. The kids that were goading him for a reaction now know that their actions have consequences.

Watch it now mate it'll just make you laugh.. For me it's Flatliners, watched it once but one day when my mates and I had been on a bender, we decided to watch it again and it freaked me out so much I can't watch it now.

I'd get yourself down the docs for a check up mate. You might still be getting over what you had before. I've been very listless since I had man flu the other week as well. Hasn't helped that I hit my thumb with a hammer three times today while changing my suspension!

I've already been attacked three times by bloody wasps in the kitchen! Apart from that 'tis gorgeous weather here.

I ended up getting a tub of CV Lith Moly grease from halfrauds. It's much better to work with than that really sticky stuff E.S. supply.

Welcome matey :)

Welcome matey :)

Is Castrol Moly grease OK to use on poly bushes for the control arms etc.. I've run out of the stuff you get with the bushes as I keep dropping the buggers and having to clean them :helpsmilie:

My Vectra GSi has a top speed of 149, I've had a 143 out of it and it still had a bit more to give (not much though). I would expect the NA zed to be faster, based on 30odd more bhp and its lighter and has a better gear ratio. This obviously isn't a scientific conclusion!

That sounds like the bolts for the coil packs, there should be 12 of them. They sit between the pipes on the plenum.