vijay

I'll try the stuff from Homebase. Is the one from Frost just a big bag of silica gel?

Although I can understand lowering to 20mph near schools but got to agree that kids need to be educated in road safety. Got a secondary school down the road on a 30mph road. There's a zebra crossing right outside the school gates but the amount of kids that either don't use it or they stand by the edge of it waiting for their mates, so people stop when there's no one to cross.

Didn't know that :) Will it not mark with stone chips though?

Hi, Getting a hell of a lot of condensation in my Z which is sitting on my drive. Any suggestions how I can limit the amount as it's not being driven at all. Vijay

How do they stand up to stone chips?

good tip is to cut a slot in the nightmare bolt that you have to get to from underneath, then you can use a screwdriver from above next time ;)

Probably here :) http://www.300zx.co.uk/forums/forumdisplay.php?f=41

very very nice, I've got that same job to do in the new year.

Hi Sudesh, AndyP is your man for fixing clocks ;) Vijay

Maybe contact Autowatch. I needed the installation manual for my Cobra alarm and Cobra were most helpfull in faxing it over. Worth a try :)

Hi Andy, What do you mean by "tunable"? can you callibrate them?

Managed to get it out with a hammer and bar in the end. New bearings went in today so just have to get the whole thing back together now :)

Put it this way, if you see the way they work and the set up they have, I'm sure you'll be impressed with the guys at Custom Exotics. Very nice friendly guys too who let their work do the talking ;)

shame cos the last thing I intend to do is cut holes in my bumper :(

I had mine done and it's been an absolute nightmare! The first 2 bodyshops standard of work turned out to be utter shi**. Thankfully after a recommendation from a few people here, my car ended up with Custom Exotics in Harlow. They ended up sorting my car out nicely and went above and beyond to get things right. Needless to say I wouldn never take my car to anyone else from now on and can't recommend them highly enough if you're looking for honest guys who take pride in the work they do :)

ZX-TT, are there any that are reliable that you don't have to cut into the bumpers? Vijay

this should cover it - http://www.ttzd.com/tech/bushingstech.html

Did you ever get these? if so how did you find them?

try and soak them in WD40 before you start (maybe the night before) as they could be stuck tight

Wouldn't the heat cause a problem with the plastic drum though?

It's my Mum's machine and don't want to spend 500 quid on a new one cos of a bearing seal ;) No space to get a grinder in there but will try a resipricating saw

Hi, Trying to remove a bearing out of a washing machine that's stuck solid. Any ideas? I've soaked it in WD40, hit it with a hammer, tried and air chisel. Can't use any heat as the drum it sits in is plastic. Cheers Vijay

Hello bud, Can check tomorrow for you as there's no interior at all in my car at the moment so should be able to see where it goes

http://www.300zx.co.uk/forums/showthread.php?t=63938&highlight=oil

might help - http://www.300zx.org.uk/mod_comp_0.htm