steviecopland

Well think i will keep the fogs then. Cheers for the advice.

So is there two types of indicators for the 99-spec then, seems to be two opinions here and am still confused.

Yeh was gutted, your a lot cheaper. Something to do with no VAT is it?

cheers, think that's the way to go then. Does your carbon ducts bolt onto the bit that the fogs do or are the bonded to the bumper? Also do you know what that little black thing is that is screwed onto the bottom of the black thing that the fogs are onto? Looks like a sensor or something. So many Q's mate.

If i was to fit a 99spec bumper does the indicators to suit it have side lights in them aswell???

I got the unorthodox from the z centre then seen i could get it a fair bit cheaper from smithys. Almost to nice to put on my car and was also very shocked at just how light it was.

My car is a J-spec and has no rear fogs that am aware, and the front lights on my bumper come on when the side lights are turned on if that makes any thing more clear cause am still none the wiser.

Just another brain picker, does the Z need the front fog lights to pass the M.O.T cause i want fit carbon ducts but don't want to have to change them back for the M.O.T :confused:

Cheers spoke to Mike and got them ordered.

Yeh the one on the tensioner feels nice and smooth, it's the others that am looking for. If the one on the tensioner and the other two are all "interchangeable" will be more than happy to take it off your hands, just need to find out first.

will do bud.

Can anyone tell me how much the two bearings that the cam belt runs on costs and where the best place to get them? Think they are the same as the one on the cam belt tensioner.

Thanks.

Will the plastic primer be ok for the top two cam covers aswell bud?

Cheers, did you get my PM about the new membership pack?

Hi, can anyone tell me if i can use normal car body paint on my cam covers and throttle cover or if it can have laquer on it? Don't want to have to paint them twice. cheers

Wish i had that crow helping me with my Z.

Ta olliezx.

Hi FASTREDZ did anyone ever find out about the Ash-spec rad as i still have to sort out my membership sometime this week but i can't find the old thread about them. Cheers.

Can't belive i never thought of that, just have to hope the old studs don't snap or pump off i guess.

So will a carbon shroud fit on this or would u have to fit it on top of the red one in the pic? Also would the bolts that keep the viscoise fan in place go far enought on to keep the puley on as i have noticed the studs have a 5mm unthreded steam and the pulley is not that thick.

Can you tell me if the viscouse fan and shrould can be removed if i fit this rad? Looking to clear up the engine bay a bit pal.

Hi first post, how much do u think these may cost cause i also need an uprated rad cause am doin a bit of a build???