Could anybody tell me where the cruise control actuator plugs in under the bonnet. My car is made from 3 different zeds. The shell is a 1990 jdm import. The engine and harness are from a 1995 import which did not have aircon. Any help would be greatly appreciated.

Usually wrapped up with tape to the left back side near the small fuse box.

 

But not all zeds have cruise and it can't easily just be added in. :(

That's what I thought, is it possible that it might have fallen down low during engine swap. mine must have aircon as I distinctly remember undoing that oval plate on bulkhead with two large pipe nuts to install engine loom.

 

Sent from my SM-N910F using Tapatalk

Top left by the BMC. Usually gets tucked down. From memory is a square grey plug.

What's the bmc??

 

Sent from my SM-N910F using Tapatalk

Sorry, silly me, brake master cylinder. I will have a good explore tonight. Do you know what loom it's on??

 

Sent from my SM-N910F using Tapatalk

Usually wrapped up with tape to the left back side near the small fuse box.

 

But not all zeds have cruise and it can't easily just be added in. :(

Sorry, don't know why I've ended up talking about air con. I will take a look and see if it's buried somewhere below. If it's part of the engine harness that would explain it, as it's out of a vehicle which didn't have cruise

 

Sent from my SM-N910F using Tapatalk

It's not part of the main engine loom.

 

It's attached to the main electric loom near the small fuse box.

 

If your zed never had cruise to start with there will be a whole load of stuff missing including the cruise ecu.