MOT time and the indicators pack up!!

 

10amp fuse in drivers foot-well checked.

Hazards work ok.

 

 

Any ideas?

 

:sweatdrop:

Hazard switch in the left pod is linked like an overide to the indicators.

 

Have you tried popping the relay switch off the loom in the pod incase its just a bad connection.

have you had the hazards on somtimes the switch gets stuck and don't go right back [off ] this happend on mine

Cheers Guys.

 

Funnily enough, I did have that pod off recently and had problems with the hazards switch!!!

 

I'll check it out in the next few days.

Yep check the plug is all the way home on the back of the hazard switch. The hazards would still work but if the plug isnt in properly you indicators wont.

have you had the hazards on somtimes the switch gets stuck and don't go right back [off ] this happend on mine

 

Yep check the plug is all the way home on the back of the hazard switch. The hazards would still work but if the plug isnt in properly you indicators wont.

 

Both spot on!!!!!

 

Cheers guys!! A little wiggle of the hazards switch and it's fine!!

Yep had that before and spent ages writing a chart out on voltages then wiggled the switch and all was well - pain in the bum! :)

 

Glad you got it sorted buddy!

Not sure anyone mentioned it but sometimes the hazards switch gets stuck done ;) hehe

Yep had that before and spent ages writing a chart out on voltages then wiggled the switch and all was well - pain in the bum! :)

 

Glad you got it sorted buddy!

 

cheers!

 

Not sure anyone mentioned it but sometimes the hazards switch gets stuck done ;) hehe

 

I'll go and check........