Does anyone know where i can find a photo of the vaccum line i'm supposed to fit my boost guage too, spent 2 hours getting it through bulk and now im sick , just dont want to cut the wrong pipe...i have no clue at all which one.:(

bump

Ive not got a picture but when i connected mine, i put a t-piece into the single hose that comes off of the drivers side of the balance bar. I'd wait for someone else to confirm thats ok before you do it though.

no probs, cheers

take your pic mate :)

 

 

 

the one on the balance bar is the most common to T into.

Is this the same pipe to cut into for the boost controller T?

Is this the same pipe to cut into for the boost controller T?

 

depends which pipe you mean for the boost controller?

The 3mm single pipe and not the solenoid 8mm pipes lol

if you look at the diagram, there are 3 points on the balance bar (the blue lines)

 

any one of these are fine.

 

 

lots of the stuff can be deleted out of the vacuum system, AIV, EGR, FPRV.

 

when you delete these, you could just plumb your boost gauge to where they used to go.

Sorry for the hijack but thanks very much for the help :)

think i have it sorted, will fit today sometime, i'll cut into the blue hose left of the fuel damper (not hose to) near the balance bar think thats the one your telling me to cut z32 and thanks so much

Sorry for the hijack but thanks very much for the help :)

 

no probs, happy you got sorted. It's a right pain getting something that has very vague instructions and even worse when its off ebay with none lol

Heres mine, i only fitted it today and im not 100% sure if its correct but the gauge does move lol so.

 

Edited September 30, 200916 yr by rob3bot

thats fine buddy :)

rob3ot,

 

your is the one which goes to the FPRV. which is fine.

 

there is another similar take-off in front of it, which is for the passanger side re-circ

got it fitted, thanks to everyone :-)