greg

HAHA no more whoreing for mr pimp magic PMSL

thats the only niggle with forums sarge is everone believes what they want to believe its a bit crap really but as you say life goes on i am surprised **** is still allowed on this forum fookin arse ache :xxx: case closed PMSL

u nutta

Ffs

try replacing the oil with a fully synthetic 10-40 or 10-60w use the correct amount 4ltrs is normally perfect which includes the filter if still noisy its probable the lifters have been drained of oil or lacking,also lets hope the bottom end bearings havnt been damaged from oil starvation if its lifters its plenum off and covers and camshafts and 24lifters replaced @£12 each approx. hope some new oil helps greg

check TPS settings should read 0.40-0.50v at idle can be set using a multi meter connecting the red probe to the centre wire coming from the tps connector passenger side of the plenum then ajust the 2 x7mm screws carefully until voltage of the above figure is achieved reset ECU clean temp sender do a consult check! check iaa unit clean warm up idle connection clean unit if required theres an article on tt.net. set base idle using ajustment screw on side of IAA unit dont mess with the IAA unless all the other jobs fail to cure! boost leaks? dirty connections? theres a few problems that cause symtoms like hesitation/erratic idle start with the simplist then work through start with removing the battery for an hour then reconect,you will surprised what a simple thing like that can do by resetting the ECU

fooker hijack over hehe

good luck mate i had to make a choice it was either sit in debt and stress or do something about it breaks my heart but she went to a good home not the fookin RSPCA before blackmagic has a joke up his sleeve :xxx: :tongue: good luck anyhow

good luck paul with the venture ;)

get on msn marcus

cant make it that day

off topic jim! im off work this week so if you still want speakers done im home this week,back to work as of next week. :) greg

it can be dont but it just isnt worth the stress you would have to bend 13mm spanners to get to the manifold nuts,water feeds etc but to answer the question it can be done steveo did it on here but it was a mission IIRC

2 SMs

fookin ell £450 3hours tops and £10 for seal £150 max

well heres me PMSL chillin

i think i played that jim LOL is that where you have to cross a busy motorway and then go down the ski slope :smash:

happy birthday

NISSAN Nissan International Sports Society Arseholes Not alowed

all the best

cheers sarge good to be back time to whore wheres blackmagic when you need a whore :wack:

splatter house was good,as was r-type but difficult as once your dead your dead i seem to loose interest in games quickly i play them sold for hours then dont play them for weeks i think its due to the fact there easier due to the saving process with mem cards bring back paperboy PMSL

my vfr will keep up with a stock z :smash:

nah steve z through and through and always red mate

agreed