Steams

Your not neglecting her are you mate :slap: Need to get it sorted, I can't have a pink zed sitting in my drive, what would the neighbours say!

Can you ship the z31 to me before you blow yourself up mate ;). Haven't got a clue mate, I'm sure you'll get it work with your woodworker wizardry though buddy :)

Daz mate, your going to rip a hole in the fabric of time one of these days with your madcap inventions...:lol:

If you do replace the lines, I think you'd need to get the non-abs bmc, it has an oulet for each wheel rather than just front and back.

Another thing to check is BMC seals, they can under too much pressure pop outwards. This breaks the barrier between front and rear and causes all sorts of braking problems.

Don't blame you mate, it's really frustrating having a zed just sitting in the drive. I know all about that lol. Have you done any work on the brake lines? Reason I ask is that I had a hell of a job bleeding my brakes after I'd replaced the lines. I tracked it down to one of the connections near the ABS not being fully tightened. It was tight enough to not leak but was sucking air in when I released the pedal. Might be worth a look?

Pretty sure you'd have gone out of business by now if you didn't mate :thumbup1: Just because someone doesn't speak English very well is no reason to ignore them.

Loving the stance and the wheels mate. :thumbup1:

It does sound like air in the system, but as for how you bleed it..... Thought you were going to delete it mate?

I've never heard that before mate, I would check with them again If I were you.

lol. Always the way isn't it. So is this your one or a family one?

yeah, I was wondering if it was caused by the rad. It's quite hard too see as well due to the stuff in the way. But that one is pretty obvious...

Glad mine's solid, not a job I fancy doing anytime soon. lol

Jeez, I'm surprised that hasn't snapped by now. Is it fixable with a donor part Jeff?

oh dear.....:no:

Just goes to show how far moisture can travel up the loom. I put a little blob of liquid insulsator tape on the back of my connections. Probably not going to stop it but makes me feel better.

Agreed Bri, vey helpful Jeff. To add I've also seen what looks like perfectly good wiring but when cut open, the wire has been green with corrosion.

Thanks Jeff, good to know... Edit : D'oh didn't see the bit about the fan, really should read better.

Could this be caused by the thermostat being stuck?

Looks like a nice one Jane :thumbup1:

:lol:

I've never been but I'm sure the scenery is lovely, and my cat can speak better English than some english people :)

Probably a good thing, you'd be scrolling for hours getting through daz's sig...:lol:

Good one :lol::lol:

:lol: