Steams

Have a search on "Targa leaks" there are loads of threads on this and it sounds as though that's what happening.

...

Does anybody know what size split pins I need for the Hicas tie rods? I'm thinking it's 2.5mm dia but wondering if anyone can confirm this? Cheers

Welcome Matey :)

Welcome matey :)

The first pic is indeed the water temp sender for the ecu, the one next too it is the sender for the temp gauge. Try Mike at MJP for a replacement. I'm not too sure on the second plug

I sell a pipe that joins the two pipes out of the solenoid together. £17 delivered and comes with new crush washers. It's the same as the Z1 one but my one is hex bar, so you can stick a wrench on it. PM me if interested.

Have a good un matey!!

Sorry to see this mate. I've got exactly the same type of dent on my passenger side! The previous owner said he'd been hit in a road rage incident. I was planning on having it Pulled and filled before my respray.

Bet you can't find anything wrong with this subtle custom job mate! :sailor: It's even got BBS alloys :w00t:

Welcome matey :)

I just used a small pry bar on the bolt head to get it past the IC pipe. Didn't cause any damage as the pipe will lift enough (just) to pry the bolt out.

Welcome matey :)

Through the bulkhead where the steering column goes.

What make are the gauges? Ignore that!! didn't read the thread title properly! doh... Anyway, did they not come with any wiring diagrams?

Nice to see the club spirit working :thumbup1:

You'd need to install a pelican filter tho' :devil2::whistling:

You can adjust the rear a little bit via an eliptical bolt/washer set up. Don't think the fronts are tho'

Is that also a bloody great scratch down the plastic cover?

Sorry mate but that is minging from all angles! :pinch:

Yep Dan has pm'd me mate so all in hand. Many thanks Isn't this what causes the the ps pump to fail due to pressure build up?

Sorry mate, I completely missed your post :blushing: If you'd still like one then please email me at a_db_models@btinternet.com. cheers Dave

From reading the title of the thread, I was going to say "that's called rust mate" lol Mine are all smoothed as well.

I intend to lower my zed off the axle stands on to 4 (identical) ramps. This should (in theory) have the car sitting level and full loaded, so I can then get easy access to torque up all the bolts that are bushed. I've got practically every suspension part to do front and rear :sailor:

:oops: