vijay

Hi Chris, That would normally be the front footwells. Vijay

are you sure? 1/8th is tiny. This is bugging me now lol. Now I seem to think you're right. Vijay

Hi, Any ideas why I would be getting damp in the passenger side rear footwell. Gonna pull up the carpet tomorrow but just wondered if anyone has had this before. Cheers Vijay

This has come up a few times so I thought I'd take a few pics and measure up the 90 degree elbow I used to fit a sender unit in the 10mm hole near the oil filter. The problem if fitting the sender straight into the hole is it will foul on the steering arm. To get round this I used a 90 degree elbow which is roughly 1"x"1 and a male to female. For my sender unit it was a 1/8" NPT fitting which I think is pretty standard. Wrap PTFE around the male ends about 3-4 times to make a tight fit. Hope this helps. Vijay

http://www.symatix.co.uk/300zx/EngineRemoval/EngineRemoval.htm

Here you go :) http://www.300zx.co.uk/forums/showthread.php?t=59255&highlight=primera http://www.300zx.co.uk/forums/showthread.php?t=60451&highlight=primera Vijay

there's a switch in the locking mechanism for your boot light. Check if that's on too as it'll drain your battery. Vijay

Peanut oil! Vijay

Put it in the for sale section, I'll look back through PM's to see if there was anyone. Vijay

thanks guys. The lighter didn't seam to work but running the soldering iron up and down the wire worked :) Cheers again everyone. Vijay

Here you go :) http://www.ttzd.com/tech/bushingstech.html Vijay

tried heating it and still nothing. Scraping it just cut the wire :( Anything else I can try? Thanks Vijay

what sort of ball park figure? Cheers Vijay

could you not use a relay with a remote wire from your stereo/ignition so it's only charging then? Vijay

it's new headphone wire. Seperate flux - what's that about then? lol Vijay

Hello Steve, I honestly have no idea what clocks you have but they are not a series 1 or 2. The only difference between those versions were the locating holes. You have to choices, either try and sort the correct clocks out or we'll have to try and sell the dials on which I shouldn't see as a problem. Vijay

Hi, Why does solder melt into some wire and not others?? Cheers Vijay

It seams that removing Norton sorted it. Why would it cause it to run so bad???? Thanks to everyone for the help and advice. Vijay

yep, slow as in changing screens and loading apps. CPU usage is very low.

Hi, Cheers for the help. Where can I see the "memory used"? Vijay

Morning, Got a problem with my neighbours PC. I've formatted and re-installed XP but the PC is running extremely slow. I've run Norton Antivirus and it's coming up with nothing. I've also updated windows. Any ideas? Cheers Vijay

up near the ecu. It should run through a hole and come out under the car. Vijay

Hi, As Steve says, can you post a pic cos they should fit. Vijay

make sure the air con drain pipe is fitted correctly, mine wasn't and had the same problem. Vijay

http://www.twinturbo.net/ttnettech/throttle/throttle.html