This is the only picture i can find of it on the car. I must have deleted all my old pictures... DOH

 

I have raked it out of the garage and it looks a bit dirty. So I have cleaned it as much as I could. Do you all think I should put this back on the car instead of that monsterous thing I currently have?

 

 

 

 

 

 

And after I cleaned it a bit

 

 

 

 

 

looks in a pretty poor state Tbh, wont be long before it starts developing holes

so best leaving the big one on then?

I wouldn't put that on my car!

 

There's someone on here selling a Veilside Evolution system. One of the finest system built for the Z.

after the money and work thats gone into your car.. your having a laugh arnt ya lad

Was just thinking mine looks crap (too big lol.

 

I thought the veilside one was sold

Just checked, it is.

I was thinking about buying it when it came up as sold

Shame, you'd love it. Not only is it very very well built, it sounds amazing too.

I was thinking about buying it when it came up as sold

 

this is what they look like Lee..

Yup, I did see that picture but it went before I had a chance.

 

What do you think in the meantime though? leave the big one on?

This one

Yup, I did see that picture but it went before I had a chance.

 

What do you think in the meantime though? leave the big one on?

 

thats on mine the one in the pic...just leave yours till a nice one comes along then you do the job once instead of twice:D

This one

 

:shock: ide slash cut 6" off that mother asap

Donkey Dick! Bit of a trim needed on that one.

so if i just take it to an exhaust place and ask them to cut it back a bit?

Yeah. The tips are sooooooooo long. Get them to cut them back from the box as they look like they are rolled on the tips. They just need shortening a little.

get them to cut it with a chain cutter as it curls the edge in at the same time so you aint got that "hacksaw cut" thing going on:)

get them to cut it with a chain cutter as it curls the edge in at the same time so you aint got that "hacksaw cut" thing going on:)

 

 

Get them to cut and reweld the tips. He'll loose the 'roll' otherwise.

Get them to cut and reweld the tips. He'll loose the 'roll' otherwise.

 

get them to cut and blow as he'll lose the curls otherwise...where the fvk did that come from:confused::rofl::rofl::rofl:

....I'd get them to remove this section....

 

.....or, if you're feeling Adventurous, get some custom tips made like the ones on the Lotus Carlton. They'll fit the cutouts each side then. :)

 

If I was going custom, that's how I'd have them done.

 

and get them to cut these out at the same time:)

lol, I think it hangs down a bit too low too

It does, but only because of the elongated tips. Shorten the tips as per my diagram and they will not look as low.