Is there any MAF upgrade available for a TT, can you fit a bigger one off another Nissan for better airflow?

Is there any MAF upgrade available for a TT, can you fit a bigger one off another Nissan for better airflow?

 

you mean maf or throttle bodies bud???

http://www.z1motorsports.com/product_info.php?cPath=6_18&products_id=1911&osCsid=213547096b1f081d786ecb47402cc31b

you mean maf or throttle bodies bud???

http://www.z1motorsports.com/product_info.php?cPath=6_18&products_id=1911&osCsid=213547096b1f081d786ecb47402cc31b

 

The MAF, I will look into the TB's later.

300zx maf is an upgrade for the 200sx

 

But I dont think nissan made a maf system that could handle more than the 300zx one

 

You need to get an aftermarket afm system if you want to go bigger in that direction

 

Anyone know what the highest power output has been got using the stock maf system?

you could wire a q45 maf up which is massive but tbh if you need to go down the route of running a higher output maf then you should be thinking of going for a map setup anyway ;)

you could wire a q45 maf up which is massive but tbh if you need to go down the route of running a higher output maf then you should be thinking of going for a map setup anyway ;)

 

The car will have a new ECU for the new set up, I just wondered if a standard MAF was good for 600bhp or it there was an upgrade available?

The car will have a new ECU for the new set up, I just wondered if a standard MAF was good for 600bhp or it there was an upgrade available?

 

After about 450-500hp those that dont go for a MAP setup go for a Twin MAf setup instead

After about 450-500hp those that dont go for a MAP setup go for a Twin MAf setup instead

 

So with a new ECU/Map then the standard will cope?

So with a new ECU/Map then the standard will cope?

 

when i say MAP i mean an new ecu which uses a MAP sensor and gets rid of the MAF LOL confusing i know

 

Mike

when i say MAP i mean an new ecu which uses a MAP sensor and gets rid of the MAF LOL confusing i know

 

Mike

 

 

Got it!!:D

Got it!!:D

 

then the new ecu would need a fuel MAP :D

 

i ran the AEM ecu with a 3.5 bar MAP sensor, much easier when building a high power car